Quantum Audio Scalar 50 installation instructions Fibre

Page 8

Quantum Scalar 50 Tape Drive Installation Instructions

Document 81-81769-01 B01

September 2007

Figure 4 Scalar 50 Cable

Configuration (SCSI Full

Height Drives)

Ethernet	System Controller Board	SCSI host
		SCSI host
	Tape drive 2	Tape drive 1
	Power	Back of Library
	Power

Figure 5 Scalar 50 Cable	Ethernet	Back of Library
Configuration (Native Fibre
Channel Full Height Drives)

Tapedrive2

Tapedrive1

Fibre

Channel

Power

Fibre Channel

LTO Tape drives

host/SAN

shown. SDLT drives

have a single FC port

Figure 6 Scalar 50 Cable

Configuration (SCSI Half-

Height Drives)

Ethernet	Terminator	Back of Library
	Tape drives	Tape drives
	3 and 4	1 and 2
	Power	SCSI host

8	Cabling the Tape Drives

Image 8

Contents Quantum Scalar Tape Drive Installation Instructions Quantum Scalar 50 Tape Drive Installation Instructions Document 81-81769-01 B01 SeptemberCOPYRIGHT STATEMENT TRADEMARK STATEMENTIntroduction Unpacking the Tape Drive Installing the Tape DrivesCabling the Tape Drives Setting the Tape Drive SCSI ID Completing the Native Fibre Channel InstallationScalar 50 Tape Drive Upgrade Kits Figure 2 Scalar 50 Cable Configuration Half-Height DrivesTable 1 Tape Drive Upgrade Kits SDLT SDLT Part NumberLTO Part PC-KUCQA-YF LTO-3 HH SCSI, single driveNumber PC-KUC1A-YF LTO-3 HH SCSI, dual driveRequired Tools Installing the Tape DrivesUnpacking the Tape Drive Cabling the Tape Drives Proceed to Cabling the Tape DrivesFibre Tape drives Figure 7 Scalar 50 Cable Configuration Native FibreChannel Half-Height Drives Configuration Stacked Document 81-81769-01 B01 September Figure 8 Scalar 50 CableScalar 50 slave library Host computerSetting the Tape Drive SCSI ID Setting the SCSI ID Using the OCPSetting the SCSI ID Using the OCP Setting the SCSI ID from the Remote Management PagesSetting the SCSI ID from the Remote Management Pages 3 Enter the username and password and click OK Completing the Native Fibre Channel Installation Using the Remote Management to Determine the WWNs Determining the WWNs World Wide NamesDetermining the WWNs World Wide Names Verifying Library Connectivity Library/Tape Drive World Wide Name e.g4 Click Setup from the contents frame The management frame displays the Setup page see figureFigure 17 Setup Page 5 Click on the SCSI/Fibre tab The SCSI/Fibre page displays see figuretype Tape drivesWorld wide name Media changerConnect Via a Telnet Session Verifying LibraryConnectivity Connect Via a Web Browser Connect Via a Telnet SessionSCSI ID Assignment with Native Fibre Channel Tape Drives Fibre Channel Connectivity TroubleshootingConnect Via a Web Browser SCSI ID Assignment with Native Fibre Channel Tape Drives To display the SCSI ID assignments Document 81-81769-01 B01 September 81-81769-01 B01 81-81769-01 B01