Quantum Audio Scalar 50 Tape Drive Upgrade Kits, SDLT Part Number, PC-UUAQA-YF DLT-S4, SCSI

Page 4
Figure 2 Scalar 50 Cable

Quantum Scalar 50 Tape Drive Installation Instructions

Document 81-81769-01 B01

September 2007

Figure 2 Scalar 50 Cable

Configuration (Half-Height

Drives)

Tape drives

Tape drives

3 and 4

1 and 2

Back of Library

Scalar 50 Tape Drive Upgrade Kits

Table 1 Tape Drive Upgrade Kits (SDLT)

The tape drive upgrade kit differs depending on the tape drive type needed for the library. Refer to the following tables:

•Table 1 for SDLT tape drives kits

•Table 2 for LTO tape drive kits

SDLT Part Number

PC-UUAQA-YF (DLT-S4, SCSI)

 

PC-UU8QC-YF (DLT-S4, Native Fibre)

DLT-S4 Tape Drive

 

Module

 

4

Introduction

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Quantum Scalar Tape Drive Installation Instructions Quantum Scalar 50 Tape Drive Installation Instructions Document 81-81769-01 B01 SeptemberCOPYRIGHT STATEMENT TRADEMARK STATEMENTIntroduction Unpacking the Tape Drive Installing the Tape DrivesCabling the Tape Drives Setting the Tape Drive SCSI ID Completing the Native Fibre Channel InstallationScalar 50 Tape Drive Upgrade Kits Figure 2 Scalar 50 Cable Configuration Half-Height DrivesTable 1 Tape Drive Upgrade Kits SDLT SDLT Part NumberLTO Part PC-KUCQA-YF LTO-3 HH SCSI, single driveNumber PC-KUC1A-YF LTO-3 HH SCSI, dual driveUnpacking the Tape Drive Installing the Tape DrivesRequired Tools Cabling the Tape Drives Proceed to Cabling the Tape DrivesFibre Channel Half-Height Drives Figure 7 Scalar 50 Cable Configuration Native FibreTape drives Configuration Stacked Document 81-81769-01 B01 September Figure 8 Scalar 50 CableScalar 50 slave library Host computerSetting the Tape Drive SCSI ID Setting the SCSI ID Using the OCPSetting the SCSI ID Using the OCP Setting the SCSI ID from the Remote Management PagesSetting the SCSI ID from the Remote Management Pages 3 Enter the username and password and click OK Completing the Native Fibre Channel Installation Using the Remote Management to Determine the WWNs Determining the WWNs World Wide NamesDetermining the WWNs World Wide Names Verifying Library Connectivity Library/Tape Drive World Wide Name e.g4 Click Setup from the contents frame The management frame displays the Setup page see figureFigure 17 Setup Page 5 Click on the SCSI/Fibre tab The SCSI/Fibre page displays see figuretype Tape drivesWorld wide name Media changerConnectivity Verifying LibraryConnect Via a Telnet Session Connect Via a Web Browser Connect Via a Telnet SessionConnect Via a Web Browser Fibre Channel Connectivity TroubleshootingSCSI ID Assignment with Native Fibre Channel Tape Drives SCSI ID Assignment with Native Fibre Channel Tape Drives To display the SCSI ID assignments Fibre Channel Connectivity Troubleshooting 81-81769-01 B01 81-81769-01 B01
Top Page Image Contents