ADD USER |
|
| |
P.T.Z. CAMERAS | CHAPTER 8 | ||
Click Add in User Configuration to access | |||
the Add User area. | If you are installing a PTZ camera, then the PTZ controls must be set up before operating the | ||
| camera. You should have your PTZ camera’s manual handy when configuring and operating | ||
Enter the user name, password, confirm | the PTZ camera for the first time. You should have the information regarding the Baud Rate, | ||
password and select user rights, and then | Protocol and Address ready before you begin. |
| |
click OK. |
|
| |
PICTURE | 8.1 P.T.Z CONTROL CONFIGURATION |
|
| The PTZ settings are found in the Configuration menu. Click on the wrench icon on the | |
Delete User | right side of the Display Interface to enter the Configuration menu and then click on the | |
PTZ menu to configure its settings. | ||
Select the user name in User | ||
| ||
Configuration, and click Delete, and |
| |
confirm delete. |
| |
| PICTURE |
PICTURE 8-1
PROTOCOL SETUP
You can select different protocols, serial port number for P.T.Z devices.
The settings you enter here must match the setting on the PTZ camera.
Port - Users can set serial port number. |
| |
Protocol - Communication protocol of the |
| |
P.T.Z device. | PICTURE | |
SuperDVR supports the following protocols: | ||
| ||
DSCP, |
| |
PelcoP, Star, VIDO, VISCA |
| |
Address - Communication address of P.T.Z |
| |
device (ID number) |
|
CHAPTER 8 P.T.Z. CAMERAS
48 | 49 |