Ultratec INTELE-MODEM manual Communication Settings

Communication Settings _____________________________________

1–Communication code (The default is Automatic code detect)

This command has three possible settings: Automatic code detect, Baudot code, and ASCII code.

Automatic code detect–The modem automatically matches the caller’s code. If he or she is using ASCII, the Intele–Modem uses ASCII. If the call is in Baudot code, the modem uses Baudot.

Note that while Automatic code detect can switch codes automatically, it cannot switch speeds. If you get a call in ASCII code at 110 baud, press the Escape Key to enter command mode, type 3 to switch to 110 baud, and press Enter to return to on-line mode. Similarly, if you get a call in Baudot code at 50 baud, use the 2 Command to switch speeds.

Baudot code–The modem uses Baudot code only. The 2 Command determines whether it uses 45 baud or 50 baud.

ASCII code–The modem uses ASCII code only. The 3 Command determines whether it uses 110 baud or 300 baud.

2–Baudot speed (The default is 45 baud)

This command has two settings: 45 baud and 50 baud.

45 baud–When the modem is using Baudot code, it sends and receives at the rate of 45 baud.

50 baud–When the modem is using Baudot code, it sends and receives at the rate of 50 baud.

O–Originate/Answer (The default is Answer mode)

This command has two settings: Origi- nate and Answer. It applies only to ASCII code communication. It has no effect when using Baudot code.

Originate–When the modem is using ASCII code, it sends out an ASCII originate tone.

Answer–When the modem is using ASCII code, it sends out an ASCII answer tone.

F–Half- or Full-duplex (The default is Half-duplex)

This command has two settings: Half- duplex and Full-duplex. When you type a letter or number on your computer, this command determines how that character is displayed on the screen.

Half duplex–When the code for a typed character is sent to the modem, the modem sends it to the other computer or TTY and also sends it back to your computer for display on the screen.

Full duplex–The Intele–Modem sends the character code to the other computer or TTY only. It’s the responsibility of the other computer to send the code back for display on your screen.

This command is useful if you get double characters on your screen. You can set the F Command to full- or half- duplex in both ASCII and Baudot codes. For more information, see the Problems and Solutions section on page 21.

3–ASCII speed (The default is 300 baud)

This command has two settings: 110 baud and 300 baud.

110 baud–When the modem is using ASCII code, it sends and receives at the rate of 110 baud.

300 baud–When the modem is using ASCII code, it sends and receives at the rate of 300 baud.

E–Echo on/off (The default is Echo On)

This command has two settings: Character Echo On and Character Echo Off. It determines whether the letters you type to issue commands to the modem appear on the screen or not. It has no effect in on-line mode.

Character Echo On–When you type a command, it is displayed on the screen.

Character Echo Off–When you type a command, it is not displayed on the screen.

THE INTELE-MENU COMMAND SET • 11