Ultratec INTELE-MODEM manual Calling with INTELE-MENU Commands, General procedure

Page 9

CALLING WITH INTELE–MENU COMMANDS

General procedure __________________________________________

Set up your hardware, turn on the computer and modem, and load your communications software. Enter terminal mode. The communications program instructions will show you how to get into terminal mode (sometimes called “talk” or “on-line” mode).

1.Press the Escape Key and then the Spacebar to enter command mode. The Intele–Modem will display the following prompt on your computer screen:

Command (Press ? for help):

2.Type the letter or number for the command you want (or type ? to see the Help Menu). Commands are described starting on page 9.

3.Press the Enter Key to return to on-line mode and carry on your conversation.

If you don’t see the Command Line when you press the Escape Key and the Spacebar, try typing ATZ first. See the Problems and Solutions section on page 21 for more information.

Step-by-step instructions_____________________________________

Modem settings

When you follow these instructions, you will be using the following modem settings:

•Automatic communication mode. The modem will use either ASCII or Baudot code, depending on what it receives from the other computer or TTY.

•Half-duplex

•Pulse dialing

Instructions

1.Turn on your computer.

2.Start up your communications software.

3.Turn your Intele–Modem on. The POWER, BDT, and LO lights on the front panel of your modem will go on.

INTELE-MODEM

POWER

BDT ASC

HI

LO

CD

RXD

TXD

OH

SIG

CODE

SPEED

COMMUNICATION

PHONE

Turning on the Intele–Modem lights the Power, Baudot and Low Speed indicators.

4.Follow your software instructions to get into terminal mode.

5.Press the Escape Key and the Spacebar.

6.Type D and the telephone number you want to dial. If you make a mistake, use the Backspace Key to make corrections.

CALLING WITH INTELE-MENU COMMANDS • 5

Page 8 Page 10
Image 9
Page 8 Page 10
Contents HOW to USE Your INTELE-MODEM Ultratec, Inc Science Drive Madison, WI Contents II Contents Introduction How to make a call Information Where to find moreHow to answer a call Quick GuideHOW to SET UP Your INTELE-MODEM Setting upEquipment you need HOW to USE Your INTELE-MODEM Calling with INTELE-MENU Commands General procedureStep-by-step instructions Special situations Dialing a number lights the Off-Hook and Signal indicatorsChanging communication settings Answering with Intele-Menu commandsSetting UP AUTO-ANSWER How to use the commands INTELE-MENU Command SETTelephone Functions What each command doesCommunication Settings Message Functions Auto-Answer Functions How to call another computer or a TTY Calling with Hayes CommandsHow to answer a call from a computer or TTY How to change communication settingsSetting up Auto-Answer How to type commands Complete Hayes CommandsDefault settings Primary CommandsWhat each command means and how to use it Sensitivity The default is N1 Speaker on/off The default is M1Quiet The default is Q0 S0-number of rings The default is S0=0S4-Define line feed character The default is S4=10 S3-Define carriage return character The default is S3=13S5-Define backspace character The default is S5=8 S6-Set wait time before dialing The default is S6=2S15-Auto-answer abort enable The default is Response message list The default isCommand to reset your Intele-Modem How do I download a file? Problems and SolutionsAppendix a Specifications and Service Service information Appendix B Modem Terminology ======= AUTO-ANSWER Functions ======= Appendix C INTELE-MENU Help MenuDec Hex Char Keybd Acter Appendix D Ascii Character TableFCC Information
Top Page Image Contents