Message Functions | Ultratec INTELE-MODEM instruction

I–Hi sensitivity (The default is Hi Sensitivity Off)

This command controls the Intele–Modem’s E.A.R.S. (Enhanced Acoustic Reception System™) feature. It has two settings: Hi Sensitivity On and Hi Sensitivity Off. It only applies to Baudot communication. It has no effect in ASCII mode.

Hi Sensitivity Off–This is the normal setting for TTY conversations.

Hi Sensitivity On–This setting turns on Hi Sensitivity, which improves TTY conversations when you have a weak telephone connection or other TTY that is out of tune.

C–Current communication settings

This command displays the Communi- cation Settings section of the help menu. When you type C Command, you’ll see the listing shown below. The current settings are in parentheses.

Q–Quit to ‘AT’ command mode

This command quits the Intele–Menu command set. You can re-enter by pressing the Escape Key.

=== COMMUNICATION SETTINGS ===

1–Communication code		(AUTOMATIC)
2–BAUDOT	speed	(45)
3–ASCII	speed	(300)
O–Originate/Answer		(ANSWER)
F–Full/Half Duplex		(HALF)
E–Echo ON/OFF		(ON)
I–Hi sensitivity		(OFF)

Typing C at the Command Line displays all of the communication settings.

Message Functions __________________________________________

Message Functions allow you to type and store a message and send it later. Note that there are two separate message areas. The Message Functions area is for a message you want to save and send later. The Auto-Answer message area contains a completely different message. Any message you save in either area is kept as long as the modem is on. When you turn off the power, messages are erased.

N–Enter new message

When you type N at the Command Prompt you’ll see:

Enter new message (Y/N)

Typing Y for Yes allows you to enter a new message. Typing N for No returns you to the Command Line and preserves any message you’ve already saved. You’ll see the following prompt when you answer yes:

Enter new text message ... Press

ESC to end message

Your message can be up to 240 characters long. Press the Escape Key when you’re finished. You’ll see the

following prompt:

--------- (# chars) ----------

(# chars) is the number of characters in your message.

L–List message (0 chars)

This displays the message on the screen. When you save a message, (0 chars) will change to the number of characters in the message.

S–Send message

Send your message at any time during a conversation by pressing the Escape Key (to enter command mode) and then typing the S Key. It doesn’t matter whether you’re using Baudot or ASCII code.

12 • THE INTELE-MENU COMMAND SET