Trango Broadband TrangoLINK-45TM user manual Mac

Getting Started System Information (sysinfo) Page

********************************* 5 *********************************

[Tx MIR] 50000 Kbps [ARQ] on

[Encrypt] off [Key] 0011 2233 4455 6677 8899 AABB CCDD EEFF [Auto Rate Shift] on

[Auto Scan MU] off [RSSI LED] on

[Remarks] Remarks

********************************* 6 *********************************

[Eth Config] ANEG

[Eth Status] 100 FDX

[Eth In] 35,262,413 bytes 3 Kbps [Eth Out] 9,201,047 bytes 51 Kbps [RF In] 0 bytes 0 Kbps

[RF Out] 0 bytes 0 Kbps

[ARQ Retransmission] 0 pkts

Success.

#>

To view only a particular section of the sysinfo screen, type sysinfo followed by the desired section number.

Example:

#> sysinfo 2

********************************* 2 *********************************

[Radio Temp] 34 C [PoE Voltage] 14.2 V [Opmode] on [Default Opmode] on [Active Channel] 22 h [Freq] 5840 MHz

[Speed] 6 Mbps [Tx Power] 0 dBm [Power Range] -10..22 dBm [Peer ID] DE6159FA [Status] disconnect [RSSI] n/a [Peer IP Config] n/a

[DFS Status] idle

Success.

#>

Each of the parameters within the sysinfo screen is defined below

Section 0
[Model]	Radio Model # (P5055M)
[Unit Type]	User defined Unit Type (MU or RU)
[Hardware Version]	Hardware version set by factory (5010)
[Firmware Version]	Current firmware version loaded in radio
[System Up Time]	Time since last reboot or power cycle
Section 1
[MAC]	MAC address of radio
Trango Broadband Wireless — TrangoLINK-45	page 17