Trango Broadband TrangoLINK-45TM user manual Preface, FCC Information

Page 4

Preface

Preface

This manual covers the basic configuration and installation of the TrangoLINK-45 Wireless Point to Point Broadband System, and applies to the following radio part numbers:

P5055M-19-xx

Radio unit with internal 19 dBi patch antenna array

P5055M-23-xx

Radio unit with internal 23 dBi patch antenna array

P5055M-EXT-xx

Radio unit with external RP-SMA antenna connectors

Where “xx” denotes the regulatory configuration of the unit as follows:

US: For use in the USA

IC: For use in Canada

EU: For use in the following EU member and non-member countries:

Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland (Non Members), Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Norway (Non Members), Poland, Portugal, Slovak Republic, Slovenia, Spain, Sweden, Netherlands, United Kingdom, Switzerland (Non Members),Bulgaria, Romania

OE: OEM model for individual certification in other countries

Each radio unit is supplied with the proper mounting hardware, a power adapter, and POE box with LED indicators. Cables must be supplied by the installer.

Two radio units are required to make a TrangoLINK-45 link. The P5055M-EXT-xx must be used in conjunction with an approved external antenna (sold separately). Instead of an internal antenna, the P5055M-EXT-xx has two reverse polarity SMA RF Connectors for the attachment of external antenna cables.

FCC Information

FCC ID: NCYP5055M

The TrangoLINK-45 System is used for point-to-point operation only.

NOTE: The P5055M-EXT-xx requires professional installation due to FCC limits on output power settings when operating in the UNII band.

This device complies with Part 15 of the FCC Rules and Regulations. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio-frequency energy and, if not installed and used in accordance with these instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in any particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one of more of the following measures:

1)Reorient the antenna.

2)Increase the separation between the affected equipment and the unit.

3)Connect the affected equipment to a power outlet on a different circuit from that which the receiver is connected to.

4)Consult the dealer and/or experienced radio/TV technician for help.

Trango Broadband Wireless — TrangoLINK-45

page iv

Image 4
Contents Ffirm TrangoLINK-45 Point-to-Point Wireless Ethernet Bridge DFS Ofdm Firmware Upgrade Procedure Preface FCC InformationWarranty Information Industry Canada InformationEurope Information Email sales@trangobroadband.com Overview Adaptive ModulationARQ Dual Polarity AntennaRange vs. Throughput ISM 5725 MHz to 5875 MHz Line-of-Sight Range & ThroughputSystem Contents Location of RJ-45/LED Port & IP Reset Button Location of Serial Number & MAC AddressConnections and Power Getting StartedConfiguration Tools Changing PasswordTroubleshooting Ethernet Connections System Information sysinfoSysinfo Example MAC ARQ RssiRssi LED Getting Started System Information sysinfo Configuration Essentials to Establish a Wireless LinkMaster Unit Configuration Key ConceptsRemote Unit Configuration Changing IP Address Establishing a Wireless LinkLEDs RF Link Loopback Test linktest command Command format linktest loc speed peer speedSuccess Link Speed & Power Settings BpskQpsk 16QAMMU Autoscan Feature Description Important Note for -EU ModelsAutomatic Rate Shifting Feature Description Encryption Feature Description MIR Feature DescriptionCommand Reference Listing Configuration Command Reference Listing Configuration Command Reference Listing Site Selection Deployment & InstallationSite survey Channel Planning Rssi Command and Antenna Alignment Port Plug and Port Plate Hardware Mounting HardwareConnecting External Antenna on EXT Model WeatherizingGrounding Cat-5 Cabling ConsiderationsSnmp SnmpFirmware Upgrade Procedure Firmware Upgrade PasswordUpgrade Procedure Example 1 Upgrade main image firmware to 1.0a6From Computer Command Prompt Session Appendix a Using the Http Interface Appendix a MAC Configuration Appendix a Connection Status Site Survey Link Control Appendix B Specifications RF ParametersChannels of Operation FEC & ARQAppendix B Specifications Regulatory Compliance Data ParametersEtsi Power Parameters Power SupplyMechanical EnvironmentalAntennas Vswr