Trango Broadband TrangoLINK-45TM user manual Arq, Rssi LED

Getting Started	System Information (sysinfo) Page
[S/N]	Serial Number of Radio
[IP]	User defined IP Address of radio
[Subnet Mask]	User entered IP Subnet Mask
[Gateway]	User entered IP address of the default router or gateway on the local
	Ethernet segment
Section 2
[PoE Voltage]	The voltage the ODU received from the Jbox.
[Radio Temp]	The internal radio temperature in Celsius
[Opmode]	Operation mode of the radio: ON = transmitting, OFF= not transmitting
[Default Opmode]	Opmode which the radio defaults to after reboot.
[Active Channel]	Active RF Channel and Antenna polarization
[Freq]	Frequency of active channel
[Speed]	Modulation Speed (6,12,18,24,36, 54 Mbps)
[Tx Power]	Transmit Power
[Power Range]	Allowable power range for chosen Frequency (dBm)
[Peer ID]	MAC Address of remote radio
[Status]	Connection status of remote radio (connected or disconnected)
[RSSI]	Measured signal strength from remote radio (dBm)
[Peer IP Config]	Remote radio’s IP subnet, and default Gateway configuration
[DFS Status]	The current status of DFS.

Section 3

Channel Table: (MHz, n/a: not available in current area)

[Ch#01] 5265 dfs [Ch#02] 5285 dfs [Ch#03] 5305 dfs [Ch#04] 5325 dfs

[Ch#05] 5500 dfs [Ch#06] 5520 dfs [Ch#07] 5540 dfs [Ch#08] 5560 dfs

[Ch#09] 5580 dfs [Ch#10] 5600 dfs [Ch#11] 5620 dfs [Ch#12] 5640 dfs

[Ch#13] 5660 dfs [Ch#14] 5680 dfs [Ch#15] 5700 dfs [Ch#16] 5735

[Ch#17] 5755	[Ch#18] 5775	[Ch#19] 5795	[Ch#20] 5815
[Ch#21] 5835	[Ch#22] 5840	[Ch#23] 5840	[Ch#24] 5840
Section 4
[Area Code]		Region (country code). Defines allowable frequencies. Area code is set by
		the manufacturer and can not be altered by the user.
RF Band #1 (5180..5240 MHz)		Disabled
RF Band #2 (5260..5325 MHz)		[Power Range] -4..7/7/7/7 dBm
RF Band #3 (5480..5720 MHz)		Disabled
RF Band #4 (5735..5835 MHz)		[Power Range] -4..21/19/18/17 dBm
Section 5
[Tx MIR]		Maximum Information Rate (Mbps). User may set Tx MIR in MU and RU
		to different values.
[ARQ]		Automatic Retransmit Request (On or Off)
[Encrypt]		Encryption (On or Off)
[Key]		Hexadecimal Encryption Key (must match in MU and RU)
[Auto Rate Shift]		Automatic Rate Shift (adaptive modulation) (On or Off)
[Auto Scan MU]		Auto Scan MU (RU setting only) (On or Off)
[RSSI LED]		Enable or disable RSSI LEDs on bottom of radio. Disabling RSSI LEDs
		improves system performance.

Trango Broadband Wireless — TrangoLINK-45 page 18