Texas Memory Systems RamSan-500 manual Dhcp

To set up the network via the front panel, use the arrow buttons to cycle through the top-level menu options until the display shows “Network Config”. Use the Select button to choose this option and continue with the configuration. You may now use the arrow buttons to scroll through the following menu options:

Displays a list of the current IP configuration, hostname, IP address, subnet mask, gateway address (if applicable), and hardware Ethernet address.

Network Config

￿ Show Current Config

To continue setting up the Ethernet configuration.

Shuts down and restarts the Ethernet port using the current IP assignment configuration.

Exits the setup menu.

Network Config

￿Set IP Config

Network Config

￿Restart Network

Network Config ￿ Exit Menu

Use the arrow buttons to scroll up and down through the list. To continue setting up the Ethernet configuration, select “Set IP Config”.

After selecting “Set IP Config”, you may use the arrow buttons to cycle through:

Enables you to set a static IP address for the RamSan.

Sets the IP configuration to

DHCP

Disables Ethernet

Returns to the Main Menu without making any changes

Set IP Config

￿Static

Set IP Config

￿DHCP

Set IP Config

￿None

Set IP Config

￿ No change (exit)

Talk to your network administrator for the proper IP assignment type. Use the Select button to select the desired method of IP assignment. If you did not choose “Static IP” you are asked to confirm the selection with the ↓ button.

To configure the RamSan with a static IP, the system requires the IP address, subnet mask, and possibly a gateway address.

RamSan-500 User’s Manual 18 of 48