Telit Wireless Solutions manual 1 UC864-E Antenna connector, Pin Signal Function

Page 11

UC864-E Hardware User Guide

1vv0300766a Rev.1 - 31/01/08

NOTE: If not used, almost all pins should be left disconnected. The only exceptions are the following pins:

	Pin	Signal		Function

	1	VBATT		Main power supply

	2	VBATT		Main power supply

	3	VBATT		Main power supply

	4	VBATT		Main power supply

	5	GND		Ground

	6	GND		Ground

	7	GND		Ground

	46	GND		Ground

	25	C103/TXD		Serial data input (TXD) from DTE

	26	C104/RXD		Serial data output to DTE

	31	C105/RTS		Input for Request to send signal (RTS) from DTE

	53	ON/OFF*		Input command for switching power ON or OFF (toggle command).

	54	RESET#		Reset input

	35	USB_ID		Analog input used to sense whether a peripheral device is
	35	USB_ID		connected, and determine the peripheral type, a host or a peripheral

Power supply for the internal USB transceiver. This pin is configured

48USB_VBUS as an analog input or an analog output depending upon the type of peripheral device connected.

79	USB_D+	USB differential Data (+)

80USB_D- USB differential Data (-)

3.1.1UC864-E Antenna connector

The UC864-Emodule is equipped with a RF connector from Murata, GSC type P/N MM9329-2700B. The counterpart suitable is Murata MXTK92 Type or MXTK88 Type.

Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved

page 11 of 51

Image 11

Contents UC864 Hardware User Guide This document is relating to the following products UC864-E Hardware User GuideContents 11.2 10.310.4 11.1Disclaimer Overview Length 36.2 mm Width 30 mm Thickness 8mm Mechanical DimensionsPIN-OUT UC864-E module connectionsCmos Reserved Pin Signal Function 1 UC864-E Antenna connectorTurning on the UC864-E Hardware Commands10k Hardware shutdown Turning OFF the UC864-EHardware Unconditional Restart 10k +1.8 Power Supply Requirements Power SupplyUC864-E Hardware User Guide Electrical Design Guidelines General Design Rules1.2 + 12V input Source Power Supply Design Guidelines UC864-E Hardware User Guide Battery Source Power Supply Design Guidelines UC864-E Hardware User Guide Thermal Design Guidelines Power Supply PCB layout Guidelines Antenna Requirements AntennaAntenna Installation Guidelines Operating Range Interface levels 1.8V Cmos Logic level specificationsAbsolute Maximum Ratings -Not Functional Operating Range Interface levelsReset signal Absolute Maximum Ratings Not Functional Serial PortsSignals of the UC864-E serial port are RS232 level translation UC864-E Hardware User Guide UC864-E Hardware User Guide 5V Uart level translation UC864-E Hardware User Guide Communication ports combinations USB PortSelection Audio Section OverviewGenerality DefinitionsInput lines microphone Electrical CharacteristicsEarMT Buffers Output lines speakerNot General Purpose I/OLogic level specifications Using the Alarm Output GPIO6 Using a Gpio Pad as InputUsing a Gpio Pad as Output Using the Buzzer Output GPIO7 LED status Device Status Indication of network service availabilityRTC Bypass out VAUX1 power outputOperating Range VAUX1 power supply Mounting UC864-E on your board USB Vbus Usbid Debug of the UC864-E in productionConformity Assessment Issues Safety Recommandations Revision Date Changes Document Change Log