Telit Wireless Solutions UC864 manual Indication of network service availability

Page 45

UC864-E Hardware User Guide

1vv0300766a Rev.1 - 31/01/08

11.6 Indication of network service availability

The STAT_LED pin status shows information on the network service availability and Call status.

In the UC864-E modules, the STAT_LED usually needs an external transistor to drive an external LED.

Therefore, the status indicated in the following table is reversed with respect to the pin status.

LED status	Device Status

Permanently off	Device off

Fast blinking	Net search / Not registered /
(Period 1s, Ton 0,5s)	turning off

Slow blinking	Registered full service
(Period 3s, Ton 0,3s)

Permanently on	a call is active

Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved

page 45 of 51

Image 45

Contents UC864 Hardware User Guide This document is relating to the following products UC864-E Hardware User GuideContents 10.4 10.311.1 11.2Disclaimer Overview Length 36.2 mm Width 30 mm Thickness 8mm Mechanical DimensionsPIN-OUT UC864-E module connectionsCmos Reserved Pin Signal Function 1 UC864-E Antenna connectorTurning on the UC864-E Hardware Commands10k Hardware shutdown Turning OFF the UC864-EHardware Unconditional Restart 10k +1.8 Power Supply Requirements Power SupplyUC864-E Hardware User Guide Electrical Design Guidelines General Design Rules1.2 + 12V input Source Power Supply Design Guidelines UC864-E Hardware User Guide Battery Source Power Supply Design Guidelines UC864-E Hardware User Guide Thermal Design Guidelines Power Supply PCB layout Guidelines Antenna Requirements AntennaAntenna Installation Guidelines Absolute Maximum Ratings -Not Functional Logic level specificationsOperating Range Interface levels Operating Range Interface levels 1.8V CmosReset signal Absolute Maximum Ratings Not Functional Serial PortsSignals of the UC864-E serial port are RS232 level translation UC864-E Hardware User Guide UC864-E Hardware User Guide 5V Uart level translation UC864-E Hardware User Guide Communication ports combinations USB PortGenerality Audio Section OverviewDefinitions SelectionInput lines microphone Electrical CharacteristicsEarMT Buffers Output lines speakerNot General Purpose I/OLogic level specifications Using a Gpio Pad as Input Using a Gpio Pad as OutputUsing the Alarm Output GPIO6 Using the Buzzer Output GPIO7 LED status Device Status Indication of network service availabilityVAUX1 power output Operating Range VAUX1 power supplyRTC Bypass out Mounting UC864-E on your board USB Vbus Usbid Debug of the UC864-E in productionConformity Assessment Issues Safety Recommandations Revision Date Changes Document Change Log