Telit Wireless Solutions manual Mounting UC864-E on your board

Page 47

UC864-E Hardware User Guide

1vv0300766a Rev.1 - 31/01/08

11.9 Mounting UC864-E on your board

The position of the Molex board-to-board connector and the pin 1 are shown in the following picture.

NOTE: metal tabs present on UC864-E should be connected to GND

Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved

page 47 of 51

Image 47

Contents UC864 Hardware User Guide This document is relating to the following products UC864-E Hardware User GuideContents 11.2 10.310.4 11.1Disclaimer Overview Length 36.2 mm Width 30 mm Thickness 8mm Mechanical DimensionsPIN-OUT UC864-E module connectionsCmos Reserved Pin Signal Function 1 UC864-E Antenna connectorTurning on the UC864-E Hardware Commands10k Hardware shutdown Turning OFF the UC864-EHardware Unconditional Restart 10k +1.8 Power Supply Requirements Power SupplyUC864-E Hardware User Guide Electrical Design Guidelines General Design Rules1.2 + 12V input Source Power Supply Design Guidelines UC864-E Hardware User Guide Battery Source Power Supply Design Guidelines UC864-E Hardware User Guide Thermal Design Guidelines Power Supply PCB layout Guidelines Antenna Requirements AntennaAntenna Installation Guidelines Operating Range Interface levels 1.8V Cmos Logic level specificationsAbsolute Maximum Ratings -Not Functional Operating Range Interface levelsReset signal Absolute Maximum Ratings Not Functional Serial PortsSignals of the UC864-E serial port are RS232 level translation UC864-E Hardware User Guide UC864-E Hardware User Guide 5V Uart level translation UC864-E Hardware User Guide Communication ports combinations USB PortSelection Audio Section OverviewGenerality DefinitionsInput lines microphone Electrical CharacteristicsEarMT Buffers Output lines speakerNot General Purpose I/OLogic level specifications Using the Alarm Output GPIO6 Using a Gpio Pad as InputUsing a Gpio Pad as Output Using the Buzzer Output GPIO7 LED status Device Status Indication of network service availabilityRTC Bypass out VAUX1 power outputOperating Range VAUX1 power supply Mounting UC864-E on your board USB Vbus Usbid Debug of the UC864-E in productionConformity Assessment Issues Safety Recommandations Revision Date Changes Document Change Log