Telit Wireless Solutions manual UC864-E Hardware User Guide

Page 34

UC864-E Hardware User Guide

1vv0300766a Rev.1 - 31/01/08

Second solution could be done using a MAXIM transceiver (MAX218)

In this case the compliance with RS232 (+-5V) is possible.

Another level adapting method could be done using a standard RS232 Transceiver (MAX3237EAI) adding some resistors to adapt the levels on the UC864 Input lines.

NOTE: In this case has to be taken in account the length of the lines on the application to avoid problems in case of High-speed rates on RS232.

The RS232 serial port lines are usually connected to a DB9 connector with the following layout:

Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved

page 34 of 51

Page 33 Page 35
Image 34
Page 33 Page 35
Contents UC864 Hardware User Guide UC864-E Hardware User Guide This document is relating to the following productsContents 11.1 10.310.4 11.2Disclaimer Overview Mechanical Dimensions Length 36.2 mm Width 30 mm Thickness 8mmUC864-E module connections PIN-OUTCmos Reserved 1 UC864-E Antenna connector Pin Signal FunctionHardware Commands Turning on the UC864-E10k Turning OFF the UC864-E Hardware shutdownHardware Unconditional Restart 10k +1.8 Power Supply Power Supply RequirementsUC864-E Hardware User Guide General Design Rules Electrical Design Guidelines1.2 + 12V input Source Power Supply Design Guidelines UC864-E Hardware User Guide Battery Source Power Supply Design Guidelines UC864-E Hardware User Guide Thermal Design Guidelines Power Supply PCB layout Guidelines Antenna Antenna RequirementsAntenna Installation Guidelines Operating Range Interface levels Logic level specificationsAbsolute Maximum Ratings -Not Functional Operating Range Interface levels 1.8V CmosReset signal Serial Ports Absolute Maximum Ratings Not FunctionalSignals of the UC864-E serial port are RS232 level translation UC864-E Hardware User Guide UC864-E Hardware User Guide 5V Uart level translation UC864-E Hardware User Guide USB Port Communication ports combinationsDefinitions Audio Section OverviewGenerality SelectionElectrical Characteristics Input lines microphoneOutput lines speaker EarMT BuffersGeneral Purpose I/O NotLogic level specifications Using a Gpio Pad as Output Using a Gpio Pad as InputUsing the Alarm Output GPIO6 Using the Buzzer Output GPIO7 Indication of network service availability LED status Device StatusOperating Range VAUX1 power supply VAUX1 power outputRTC Bypass out Mounting UC864-E on your board Debug of the UC864-E in production USB Vbus UsbidConformity Assessment Issues Safety Recommandations Document Change Log Revision Date Changes
Top Page Image Contents