Timex T100 user manual Daylight Saving Time DST, Inputting the Default Password

Page 14

8.Daylight Saving Time (DST)

The DST setting (2007 forward) is as follows: The starting time is 2:00 AM on the second Sunday in March. The ending time is 2:00 AM on the first Sunday in November. The Atomic Synchronization will adjust the T100 automatically for Daylight Saving Time.

•Press <AM IN> once to set DST (press <AM IN> 7 times if just entering programming mode). The display reads “dS On”.

•Press <OT IN> to toggle between On and Off.

•Press <OT OUT> to save.

If you do not desire Two-Color Printing or Signal Tones you should exit programming mode by sliding the programming switch to “Normal”.

9.Inputting the Default Password

Input the default password to set Two-Color Printing or the Signal Tone.

•Press <AM IN> once (press <AM IN> 9 times if just entering programming mode). The display reads “00 00”.

•The default password is “1234”.

Press <AM OUT> to advance the first digit. Press <PM IN> to advance the second digit. Press <PM OUT> to advance the third digit. Press <OT IN> to advance the fourth digit.

•Press <OT OUT> to input the password and enter into Two-color Printing set-up.

Note: An “E-40” error code means the password was incorrect. It was either entered incorrectly or the default password (“1234”) has already been changed (see pg 15 for resetting the password).

Once you enter the password, it remains in effect until exiting programming mode.

11

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Page Time Clocks Table of Contents Introduction OverviewAccessories FeaturesSpecifications Template III. Location of Components FrontBackSetting IV. Quick Setting the T100Default Settings Setting the T100 Programming OutlineEnter Programming Mode Programming HintsSetting Pay Period and Current Print Line To Set Weekly Pay PeriodsSetting Year, Month, and Date Date may be set using Setting 12- or 24- Hour Print FormatSetting Time Zone Setting the Minute Printing FormatSetting the Day Change Time Inputting the Default Password Daylight Saving Time DSTSetting Two-Color Printing IN1 OUT1IN1 OUT1 Setting the Signal Tone Times Event Max Signal Tone DescriptionSetting Signal Duration Changing the Default Password Exiting Program ModeVI. Operating the T100 Punching Time CardWall-mounting VII. Installing the T100Wall Mounting Template Page VIII. Maintenance Replacing the ribbonIX. Troubleshooting Problem Possible Cause CheckError Codes Location of fusesWarranty Product Registration Card 06-0337-000 Rev. C
Top Page Image Contents