Timex user manual IV. Quick Setting the T100, Default Settings

Page 8

IV. Quick Setting the T100

The Atomic Synchronization allows you to utilize the simple steps below to set the T100.

Default Settings

Time Zone – Eastern Standard Time

Pay Period – Weekly

Daylight Savings – Automatic

Note: There are many additional options with the T100 outlined on Page 6. If you desire any of these options, proceed to the appropriate section for programming.

Setting

•Plug transformer into the bottom of the T100 and plug in transformer

•Move switch on the rear to “Program”.

•Push <AM-IN>6 times. Display will appear like:

•Press <PM-OUT>to select your time zone.

•Press <OT-OUT>to save Time Zone setting.

•Leave Timex T100 plugged in overnight. In the morning the “Atomic Time Synchronization Indicator” should be visible and the time and date will be set.

•Take a test print; if the print is satisfactory proceed to “Operating the T100” on page 17.

5

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Page Time Clocks Table of Contents Introduction OverviewAccessories FeaturesSpecifications Template III. Location of Components FrontBackSetting IV. Quick Setting the T100Default Settings Setting the T100 Programming OutlineEnter Programming Mode Programming HintsSetting Pay Period and Current Print Line To Set Weekly Pay PeriodsSetting Year, Month, and Date Date may be set using Setting 12- or 24- Hour Print FormatSetting Time Zone Setting the Minute Printing FormatSetting the Day Change Time Inputting the Default Password Daylight Saving Time DSTSetting Two-Color Printing IN1 OUT1IN1 OUT1 Setting the Signal Tone Times Event Max Signal Tone DescriptionSetting Signal Duration Changing the Default Password Exiting Program ModeVI. Operating the T100 Punching Time CardWall-mounting VII. Installing the T100Wall Mounting Template Page VIII. Maintenance Replacing the ribbonIX. Troubleshooting Problem Possible Cause CheckError Codes Location of fusesWarranty Product Registration Card 06-0337-000 Rev. C
Top Page Image Contents