Timex T100 user manual Changing the Default Password, Exiting Program Mode

Page 19

13.Changing the Default Password

The T100 uses a four-digit password to protect programmed settings. Note:

once the password is set you will be asked to enter it each time you enter

the programming mode. If you set a new password you should write it down and store it in a safe place.

Note: If a new password is lost it can be reset to the default”1234” by simultaneously pressing and holding <AM IN> & <AM OUT> buttons for 10 seconds. This will allow access to the clock’s functions without resetting the current programming. If you wish to reset the programming and password to factory defaults press the <RESET> button on back of clock with the programming switch set to NORMALmode.

Press <AM IN> once. “12 34” is displayed. (If entering programming mode begin at “Inputting the Default Password” section & continue to this step).

Press <AM OUT> to advance the first digit.

Press <PM IN> to advance the second digit.

Press <PM OUT> to advance the third digit.

Press <OT IN> to advance the fourth digit.

Press <OT OUT> to save the password.

Important: Write the new password here

Once the password has been set the T100 will display “0000” each time you enter the programming mode. The password must be entered and

<OT OUT> pressed to enter program mode. If the password is incorrect, the T100 will beep and Error Message E-40 is displayed. You will not be allowed to enter the programming mode until the correct password is entered.

Exiting Program Mode

When finished programming the T100, slide the program switch to the

NORMAL” position. Note: The clock will not function unless you exit

Programming Mode by sliding the Programming Switch to “NORMAL”.

16

Image 19
Contents Page Time Clocks Table of Contents Overview IntroductionSpecifications FeaturesAccessories Template FrontBack III. Location of ComponentsDefault Settings IV. Quick Setting the T100Setting Programming Outline Setting the T100Programming Hints Enter Programming ModeTo Set Weekly Pay Periods Setting Pay Period and Current Print LineSetting 12- or 24- Hour Print Format Setting Year, Month, and Date Date may be set usingSetting the Day Change Time Setting the Minute Printing FormatSetting Time Zone Daylight Saving Time DST Inputting the Default PasswordIN1 OUT1 Setting Two-Color PrintingIN1 OUT1 Event Max Signal Tone Description Setting the Signal Tone TimesSetting Signal Duration Exiting Program Mode Changing the Default PasswordPunching Time Card VI. Operating the T100Wall Mounting Template VII. Installing the T100Wall-mounting Page Replacing the ribbon VIII. MaintenanceProblem Possible Cause Check IX. TroubleshootingLocation of fuses Error CodesWarranty Product Registration Card 06-0337-000 Rev. C