Timex T100 user manual Introduction, Overview

Page 4

I. Introduction

Caution:

•Read and understand all instructions in the T100 User Manual before installing and operating this time clock.

•Do not install the T100 in areas where it may be exposed to direct sunlight or high temperatures, such as near a heater.

•Do not install the T100 where it may be exposed to excessive dust or to high humidity, resulting in condensation.

•Do not use this product near water or when you are wet. If the product comes in contact with any liquids, unplug the electric cord immediately. Do not plug the product back in until it has thoroughly dried.

•Securely install the time clock on a stable, level surface, or if wall mounting the T100, follow the wall mounting instructions to install it securely to the wall. Place the time clock where no one can step or trip over the cord. Do not place objects on the power cord that can cause damage or abrasion.

•If this product does not operate normally, consult the “Troubleshooting” section of this manual.

Overview

The Timex T100 is an electronic time clock that can be used for a weekly or a bi-weekly pay period. The unique Timex T111 Time Card offers a weekly time card on the front and a biweekly time card on the back. IN/OUT punches are recorded across the card in six columns by using the buttons to select the appropriate column. The T111 Time Card was made specifically to work in the T100 Time Clock. Using the T111 Time Card will ensure optimal performance.

The T100 offers Two-color Printing, so punches outside normal times will print in RED, allowing for quick and easy auditing of exception punches. The built-in signal can be programmed to audibly denote start and stop work times.

With Atomic Synchronization time setting, built-in battery back-up, auto daylight saving adjustments and a perpetual calendar, the T100 Time Clock will always print the correct time.

For more information about the WWVB Radio signal (Atomic signal) visit NIST’s website at: www.boulder.nist.gov

1

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Page Time Clocks Table of Contents Introduction OverviewSpecifications FeaturesAccessories Template III. Location of Components FrontBackDefault Settings IV. Quick Setting the T100Setting Setting the T100 Programming OutlineEnter Programming Mode Programming HintsSetting Pay Period and Current Print Line To Set Weekly Pay PeriodsSetting Year, Month, and Date Date may be set using Setting 12- or 24- Hour Print FormatSetting the Day Change Time Setting the Minute Printing FormatSetting Time Zone Inputting the Default Password Daylight Saving Time DSTSetting Two-Color Printing IN1 OUT1IN1 OUT1 Setting the Signal Tone Times Event Max Signal Tone DescriptionSetting Signal Duration Changing the Default Password Exiting Program ModeVI. Operating the T100 Punching Time CardWall Mounting Template VII. Installing the T100Wall-mounting Page VIII. Maintenance Replacing the ribbonIX. Troubleshooting Problem Possible Cause CheckError Codes Location of fusesWarranty Product Registration Card 06-0337-000 Rev. C
Top Page Image Contents