Timex T100 user manual Location of fuses, Error Codes

Location of fuses

The fuse panel is located on the back of the T100 in the lower left corner. To access fuses, disconnect the power from the clock and remove the screw that secures door. Replace blown fuse with only the same rated fuse. Do not

substitute.

1. Printer Head Fuse (1.5A DC 12V)

2. AC Fuse (1A AC 240V)

3. DC Fuse (2A DC 12V)

Error Codes

The T100 has built-in diagnostics to guide you in maintaining your time clock. These Error Codes, when occurring, will be seen on the display.

Code	Meaning of Error	Check
E-01	Clock motor or sensor failure	Unplug and reconnect power
		cord or turn the program switch
		on-off twice, letting the clock
		readjust.
E-03	Card positioning	Verify correct card (T111)
E-05	Card does not feed correctly	Verify correct card (T111)
		Re-insert card.
E-30	Printer head fails to return to	Contact dealer or Service Center
	home position
E-33	Can’t change color	Check that the ribbon is
		installed correctly.
E-35	The card can’t be returned	Make sure there are no
		obstructions in card receiver
E-37	Sensor cannot locate card	Contact dealer or Service Center
E-38	Printer head jammed	Remove ribbon and check for
		binding. Reinstall ribbon.
E-40	Wrong password entered	Enter the correct password or
		refer to section “Setting the
		Password”.

22