Ruckus Wireless 2825, 2111 manual What is Auto Provisioning?, Performing Auto Provisioning

Page 60

What is Auto Provisioning?

What is Auto Provisioning?

Using auto provisioning, either a service provider or home user can synchronize configuration parameters between the 2111 and the 2825.

In order for the adapter to communicate with the AP, the 2111 must have the same wireless settings (such as SSID, security mode, and passphrase) as the 2825. With auto provisioning, the adapter can obtain these settings without the need to use a PC for configurtation.

The auto provisioning method is very simple. You simply connect the 2111 to the 2825, and with the proper settings, all of the relevant parameters of the 2111 are securely sent to the 2825.

Performing Auto Provisioning

To perform auto provisioning, perform the following steps:

1.The adapter must be in factory default mode. If the adapter is not in factory default mode, use a pin to depress the reset button (for more than 7-8 seconds) on the back of the adapter to set it to factory default

2.When the adapter is in default mode, the right two LEDs (Wireless Device Association and the Signal Quality LED) should be blinking in unison. This indicates that the adapter is in factory default mode, and is waiting to be Auto Provisioned.

3.The 2825 should be in operation (with the appropriate wireless settings—SSID, security mode, and passphrase)

4.Connect an Ethernet cable to any of the ports of the 2825 (WAN port or any of the LAN ports). The 2825 may be connected (wired or wireless) to other devices, and video can be streamed. The other end of the Ethernet cable should be connected to a powered-up 2111.

5.Observe the Wireless Device Association and the Signal Quality LEDs of the 2111. These LEDs should continue to blink in unison.

6.The auto provisioning process will take between 5 to 15 seconds. At the end of this process, these two LEDs should turn off

7.Unplug the Ethernet cable from the 2111. The 2111 will reboot automatically.

8.Be sure that the 2111 is rebooting by checking the three right most LEDs.

9.If the 2825 and the 2111 are correctly auto provisioned and associated, the right two LEDs of the 2111 should show constant green.

2825 Parameters Included in Auto Provisioning

The following 2825 parameters are synched over to the Adapter at the completion of the auto provisioning stage (Table 20):

Table 20— 2825 Parameters Included in Auto Provisioning

Parameter

Description

 

 

 

 

Country Code

Configured country code for regulatory

 

compliance

 

 

60

Ruckus Wiireless 2825 Wireless Multimedia Router USM-2825-RKS1-012907-01

Image 60
Contents Part number USM-2825-RKS1-121206-01 January Information to the user EN 55 022 Declaration of Conformance Contents Maintenance Setting Up the Ruckus Multimedia Wireless AdapterAppendix a Technical Specifications Auto ProvisioningPreface Who Should Use this GuideWhat You’ll Find in this Guide Typographic conventionsSupport and Warranty Information System RequirementsIntroduction Key Features MediaFlexBeamFlex Media QoS Ensures Highest Video QualitySimple Configuration and Installation Intentionally Blank Installation and Setup Ruckus Wireless 2825 Wireless Multimedia Router Packing ListFront View LED Indicators and Meanings Label LED Status LightsActivity Description Rear View Rear ViewPlacement Guidelines Using the Signal Quality LED to Fine-Tune the PlacementEstablishing a good general location Describes the rear ports and AdaptersConfiguring an IP Address on Your Computer TCP/IP PropertiesConnecting Default Settings Parameter Service Provider Home UserSecurity Alert window appears Figure Click YesConfiguring Wireless Settings Choose Configuration-Wireless.The window of appearsTroubleshooting Configure-Wireless Settings CommonRuckus Wireless 2825 Wireless Multimedia Router Using the Ruckus Wireless Web Interface Wireless Settings Worksheet Wireless Network Settings Worksheet-Home UserWPA Version WPA Algorithm Settings Worksheet Wireless Network Settings Worksheet-Service Provider UserService Provider User Name Ruckus Wireless Web Interface Menus ConfiguringDevice Configuration Common ButtonsCustomizing the System Configuration Device ConfigurationInternet Configuration Configuring the Wireless InterfaceConfigure Wireless-Coimmon-Home User Wireless Interface Configuration Field Description GHz 54 Mbps 802.11g only Allows only4GHz 11Mbps 802.11b only Allows only States onlyAdvanced Wireless Settings Security Disabled ParametersField Description Describes the threshold settings parameters Threshold Settings WindowThreshold Settings Parameters Configuring WEP Describes the WEP configuration settingsConfiguring WPA WEP Configuration SettingsWPA-PSK Wireless Settings WPA Algorithm Viewing Status Information Device StatusInternet Status Status-Internet ParametersLocal Services Status Local Network Status WindowWireless Status Shows the Wireless Information Window parametersWireless Status Window Parameters BssidRuckus Wireless 2825 Wireless Multimedia Router Maintenance Performing a Firmware Upgrade by Tftp Upgrading the FirmwareFirmware Upgrade by FTP Download StartedRebooting the System Performing a Firmware Upgrade Using HttpSystem notifies you when it is done Figure Reboot MenuReboot Done Taking a System Support SnapshotMaintenance Support Info Window Administrator Information Management InformationAdministrator Diagnostics Administrator Management Window Parameters Field DescriptionAdministrator Diagnostics Window Administrator Log Administrator Log WindowRuckus Wireless 2825 Wireless Multimedia Router Setting Up the Ruckus 2111 Multimedia Wireless Adapter Placing the 2111 Into Operation Manually Configuring an IP Address on Your Computer Verifying Proper ProvisioningRuckus Wireless 2825 Wireless Multimedia Router Auto Provisioning What is Auto Provisioning? Performing Auto ProvisioningParameters Included in Auto Provisioning To perform auto provisioning, perform the following stepsFactory Reset Parameters Not Included in Auto ProvisioningPerforming Auto Provisioning Physical Characteristics Performance and Supported ConfigurationsExternal power adapter VF2825Traffic Management and QoS Management