SOYO SY-D61BA2 quick start Windows NT Users, Installing the Driver When Installing Windows NT

Page 22

SCSI Utilities

SY-D6IBA2Quick Start Guide

Windows® NT Users

This chapter explains how to install the Adaptec 7800 Family Manager Set and aic78u2.sys driver for Windows NT. The aic78xx.sys driver supports all Adaptec 7800 Family Ultra2 SCSI (and earlier) host adapters, and the aic78u2.sys driver supports all Ultra2 SCSI adapters.

If you are performing a first time Windows NT installation, see Installing the Driver When installing Windows NT. If Windows NT is already installed in your system, see Installing the Driver When Windows NT is Already Installed.

Installing the Driver When Installing Windows NT

A version of the aic78xx.sys driver (Ultra2 SCSI) driver is embedded (Included) in the Windows NT 3.5x and

4.0installation disks (or CD-ROM). During a normal Windows NT installation, the 7800 Family host adapter is detected in your system and the embedded driver is automatically installed.

Note: If you are booting from a 7800 Family host adapter and you are unable to install the embedded aic78xx.sys driver by performing a Windows NT installation, follow the

instructions for completing a fresh Windows NT installation.

The aic78u2.sys driver (Ultra2 SCSI) is not embedded on the Windows NT 3.5x and 4.0 installation disks (or CD-ROM) and must be installed after Windows NT has been installed. When completing the Windows installation, you can update the driver by following the instructions in Installing the Driver When Windows NT is Already Installed.

Completing a Fresh Windows NT 3.5x Installation

1If you choose to install Windows NT from a floppy drive, locate the Windows NT Setup Disk 1 for Floppy Installation.

If you are installing from a CD-ROM drive, locate the Windows NT Setup Disk 1 for CD-ROM Installation.

2Insert the diskette into drive A(not drive B) and turn ON your computer. When prompted, insert Windows NT Disk 2.

3From the Welcome to Setup Screen, press [Enter] to set up Windows NT.

4When prompted, select [Custom] setup.

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Quick Start Guide SY-D6IBA2 Motherboard Introduction UnpackingSY-D6IBA2 Motherboard Layout JP1 FAN1 FAN2Installation PreparationsInstall the Motherboard Install the CPUConnectors and Plug-ins Make Connections to the MotherboardEnable/Disable Power-On by PS/2 Keyboard JP1 Configure MemorySet the CPU Frequency Enable Power Button Enable JP7Power Button JP7 SettingSY-D6IBA2Quick Start Guide Select Standard Cmos Setup Quick Bios SetupSelect Load Setup Default Select Soyo Combo SetupInsert the Soyo CD into the CD-ROM drive Soyo CDRead Soyo D6IBA2 Manual Install Drivers BackFollowing drivers are available for Windows Intel Southbridge Drivers Check the Latest Releases Enter the Soyo CDScsi Utilities Installing Scsi DevicesUltra2 Scsi I/O Subsystem Pin Ultra-Wide Scsi Connector Scsi Driver Installation Windows 95 Users Installing the Driver When Installing WindowsSY-D6IBA2Quick Start Guide Updating the Driver for Windows 95 Version OSR2 Installing the Driver When Installing Windows NT Windows NT UsersCompleting a Fresh Windows NT 4.0 Installation Installing the Driver When Windows NT is Already Installed Updating Windows NTUsing Advanced Configurable Parameters Updating Windows NTUsing Windows NT Scsi Parameters To enter Windows NT parameters, follow these stepsUsing Driver-specific Parameters To enter driver-specific parameters, follow these steps Removing a Host Adapter Using Windows NT and the Host AdapterRemoving a Host Adapter in Windows NT Swapping a Host Adapter To swap adapters, follow these steps SY-D6IBA2 Serial
Top Page Image Contents