SOYO SY-D61BA2 Installing the Driver When Windows NT is Already Installed, Updating Windows NT

SCSI Utilities

SY-D6IBA2Quick Start Guide

7Highlight a driver and press [Enter].

8To add other host adapters that are not part of the 7800 Family, press [S] and repeat from Step4 for each additional adapter and insert the appropriate driver disk. The Adaptec 7800 Family host adapters use the same driver; it is not necessary to install the driver again.

9Press [Enter] to continue with the Windows NT operating system setup. Follow the instructions onscreen and in the Windows NT documentation to complete the installation.

Installing the Driver When Windows NT is Already Installed

To update or install the aic78xx.sys or aic78u2.sys driver if Windows NT is already installed, follow the instructions below for the version of Windows NT you are installing.

Updating Windows NT 3.5x

1Select and start the Windows NT Setup program. (Its icon is usually found in the Main program group0.) There is a brief pause while Windows NT Setup scans your hardware configuration.

2Select the [Options] pull-down menu and then select Add/Remove SCSI Adapter]. The SCSI Adapter setup program displays a list of all host adapters currently installed.

3Click the [Add] button to add another host adapter type to the list. A list of additional SCSI adapters appears.

4Expand the list of additional SCSI adapters; select [Other] and press [Enter]. (Requires disk provided by the hardware manufacturer.)

5Insert the Adaptec 7800 Family Manager Set diskette for Windows NT into drive A; enter one of the following paths to the installation files and then click [OK].

a:\winnt\3_5)

The screen displays the adapter drivers supported on the diskette:

Adaptec AHA-290x/291x/294x/4944/AIC-78xx PCI SCSI Controller (NT 3.5x) Adaptec AHA-294xu2/AIC-7890/91 PCI Ultra2 SCSI Controller (NT 3.5x)

6Highlight a driver, then click [OK]. The driver is added to the list of SCSI adapters.

7Select the driver form the list of SCSI adapters and click [Install]. At this point, Windows NT Setup checks to see if the specified driver has already been copied to the system disk.

8If the following message appears, click [New] to replace the existing driver and skip to Step 10. The driver(s) for this SCSI Adapter are already on the system. Do you want to use the

currently installed driver(s) or install new one(s). If the following message appears, continue with Step9.

Please enter the full path to the Windows NT SCSI Adapter files.

9Change the path to the a:\winnt\3_5 directory, then click [Continue].

The device driver is copied to your system disk and the Windows NT configuration is updated so

24