SOYO SY-D61BA2 quick start To swap adapters, follow these steps

Page 31

SY-D6IBA2Quick Start Guide

To swap adapters, follow these steps:

1.Install the driver for the 7800 Family host adapter by following the steps in Installing the Driver When Windows NT is Already Installed.

It is not essential to remove the device driver for the host adapter you are replacing. Windows NT dynamically detects the absence or presence of host adapter hardware, and no problems should arise if you leave the existing device driver installed. You may remove the device driver later, after you have successfully rebooted Windows NT. However, if you leave the driver installed, the system alerts you with an error message of the extra device driver every time you boot. See Removing a Host Adapter.

2.Once the new device driver is installed, shut down Windows NT and replace the existing host adapter with the 7800 Family host adapter.

3.Restart your computer and Windows NT. It is possible that some drive letter assignments may change from the previous configuration.

SCSI Utilities

31

Image 31

Contents Quick Start Guide SY-D6IBA2 Motherboard Unpacking IntroductionJP1 FAN1 FAN2 SY-D6IBA2 Motherboard LayoutPreparations InstallationInstall the CPU Install the MotherboardMake Connections to the Motherboard Connectors and Plug-insEnable/Disable Power-On by PS/2 Keyboard JP1 Configure MemorySet the CPU Frequency JP7 Setting Power Button Enable JP7Power Button EnableSY-D6IBA2Quick Start Guide Select Soyo Combo Setup Quick Bios SetupSelect Load Setup Default Select Standard Cmos SetupInsert the Soyo CD into the CD-ROM drive Soyo CDRead Soyo D6IBA2 Manual Back Install DriversFollowing drivers are available for Windows Intel Southbridge Drivers Enter the Soyo CD Check the Latest ReleasesScsi Utilities Installing Scsi DevicesUltra2 Scsi I/O Subsystem Pin Ultra-Wide Scsi Connector Installing the Driver When Installing Windows Scsi Driver Installation Windows 95 UsersSY-D6IBA2Quick Start Guide Updating the Driver for Windows 95 Version OSR2 Windows NT Users Installing the Driver When Installing Windows NTCompleting a Fresh Windows NT 4.0 Installation Updating Windows NT Installing the Driver When Windows NT is Already InstalledUpdating Windows NT Using Advanced Configurable ParametersTo enter Windows NT parameters, follow these steps Using Windows NT Scsi ParametersUsing Driver-specific Parameters To enter driver-specific parameters, follow these steps Removing a Host Adapter Using Windows NT and the Host AdapterRemoving a Host Adapter in Windows NT Swapping a Host Adapter To swap adapters, follow these steps SY-D6IBA2 Serial