SY-D6IBA2 Quick Start Guide
Note: If you are installing an Ultra2 SCSI host adapter such as the
Express setup loads the embedded driver aic78xx.sys included with Windows NT which is for Ultra SCSI adapters only.
5Press [S] to skip mass storage device detection. This allows you to manually select the driver for your host adapter.
6Since mass storage device detection was skipped in the previous step, Windows NT Setup displays none in the list of recognized devices. Press [S] to configure additional SCSI adapters.
7From the list of additional SCSI adapters, expand the list, select [Other], and press [Enter] requires disk provided by a hardware manufacturer.
8Insert the Adaptec 7800 Family Manager Set diskette for Windows NT into drive A and press [Enter].
The screen displays the adapter drivers supported on the diskette. For Window NT 3.5x, the following is displayed:
Adaptec
Adaptec
9Highlight the driver and press [Enter].
10To add other host adapters that are not a part of the 7800 Family, do so at this time by repeat from step 7 for each additional adapter and insert the appropriate driver disk. The Adaptec 7800 Family host adapters use the same driver; it is not necessary to install the driver again.
11Press [Enter] to continue with the Windows NT operating system setup. Follow the instructions given onscreen and in the Windows NT installation documentation.
Completing a Fresh Windows NT 4.0 Installation
1Start your system with the Window NT Boot Diskette in the floppy drive.
2When prompted, insert diskette #2 in your floppy drive. After a few moments you will see a blue screen. To setup Windows NT now, press [Enter].
3Press [S] to skip
4Press [S] again to specify an additional device.
5Press [Enter] to select Others; insert the 7800 Family Manager Set diskette for Windows NT in your floppy drive.
6Select from the following drivers:
Adaptec
Adaptec
SCSI Utilities
23