SmartBridges sB3010 Throughput Test, Click on the ‘Radio Receive’ or ‘Radio Transmit’ button

i n t e l l i g e n t w i r e l e s s p l a t f o r m

The following page shows the Link Test for the Remote Devices:

Figure 7-8 Link Test Result

7.3.1 Throughput Test

Follow the steps below to do a Throughput Test:

1.Set up a link between two airHaul units (one in Root Bridge mode and another in Remote Bridge or Router mode).

2.Enter a valid IP address of the far-end Radio.

3.Click on the ‘Radio Receive’ or ‘Radio Transmit’ button.

4.The Throughput test will start and the result will be displayed.

5.Click the ‘Stop’ button to stop the test.

airHaul™ Nexus User Guide Page 65 of 80