SmartBridges sB3010 manual Web GUI Administrator Password Change

i n t e l l i g e n t w i r e l e s s p l a t f o r m

The page information descriptions are provided in the table below:

Table 2-1 Page Information Descriptions

Page Item			Descriptions
	IP Address		Editable Ethernet IP Address.
Ethernet	IP Mask		Editable Ethernet IP subnet Mask
	Gateway		Editable Gateway IP address.
Configuration	DHCP		Editable DHCP status Disabled/Enabled
			User can enable DHCP by ticking the check box to obtain
			an IP address from the network DHCP server
	SSID		Device SSID.
Wireless	Channel		Device operation channel.
Configuration
	RSSI		RSSI value when associated
	Maximum	Wireless	Maximum Wireless Throughput in kbps
	Throughput
	ETH A MAC Address		Ethernet A (wired side) MAC address.
Port			Display only
	ETH B MAC Address		Ethernet B (wired side) MAC address.
Information			Display only
	Radio MAC Address		Radio MAC address.
			Display only
Operational	Device	operational	Current device operational mode, either as Root Bridge,
Mode	mode		Remote Bridge or Remote Router

2.2. Web GUI Administrator Password Change

By default the Administrator password is smartBridges (case sensitive).

Follow the steps below to change the Administrator password.

1.Click on the ‘Tools User Manager’ drop down menu in the navigation menu bar. An ‘Administrator Password change’ GUI will appear.

2.Enter the fields ‘Old Password’, ‘new Authentication Password’ and ‘Confirm new Authentication Password’ as shown in Figure 2-4.

3.Click on the ‘Apply Changes’ button to effect the password change.

airHaul™ Nexus User Guide Page 14 of 80