Router Configuration, Connection | Shenzhen High Power Tech H7920

Galaxy H7920 Mobile Router User Manual		Chapter 2: Installation

Attention!

Normally, the power supply is +5VDC, +7.5V~+24VDC is optional. You should check the Galaxy router label before power on.

Galaxy router should be powered by the AC adapter supplied by Hongdian. Hongdian will not guarantee Galaxy router performance if it is powered by any other unqualified AC adapter.

Connect antenna properly before power on.

2.6 Check the Mobile Network

Connect all signal and power cables, and double check it, connect antenna, insert a valid SIM or UIM (depends your router type and network) and switch on power. Galaxy H7920 router “RUN” LED will light up. If “RUN” LED is flashing, it means the Galaxy is working normally. If the “LINK” LED is flashing, it means there are data stream input/out over router data port. If the “NET” LED lights up, it means that the Galaxy router has found and logged on mobile network.

(More information refer to Chapter 4)

All cables should be connected correctly before switch on.

Antenna should be connected properly before switch on, otherwise it may cause radio module problem.

Galaxy H7920 Mobile Router User Manual	Chapter 3: Router Configuration

Chapter 3 Router Configuration

ThischapterdescribestheGalaxyrouterparametersconfigurationbeforeputtingitinservice.

1.Connection

2.Configurations

Thanks to the built-in web technology, Galaxy router can be easily configured and managed. User may be required to configure associated parameters before putting it in service. User can change settings and update firmware if it is necessary.

By the Galaxy router management web pages, you can configure and manage the router parameters. Refer to following description for details.

3.1 Connection

Normally, Galaxy router parameters should be configured through a PC. The PC should meet the requirements:

Hardware	PC with Ethernet interface, 1027x768 monitor
Software	Windows 95/98/Me/NT/2000/XP operation system
	IE 5.0 or up Internet browser

Two suggestions you can select accordingly.

Direct Connection

Connect Galaxy router RJ45 interface with PC Ethernet interface by the supplied CAT-5 UTP cable, and then set up the PC’s IP address/subnet to start the configurations.

LAN Connection

It is possible to connect Galaxy router to a hub or switch port at your the LAN environment. Therefore, any PC at the LAN can access the router and manage it.

M80-792001-01