VeriFone 3300 manual Connect the Terminal to a Telephone Line, Power Connection Port

O3300 InstallGuide.book Page 10 Thursday, November 25, 1999 3:48 PM

Omni 3300 Installation Guide

Ports for Attaching Optional Peripherals Devices:

In the center are two RJ45-type modular jacks (serial ports):

• The “RS232” serial port (icon shown at right) connects a VeriFone CR 600 check reader or other peripheral device.

•The other serial port (identified by “Bar Code” and “PIN Pad” icons at right) connects a PIN pad, smart card reader/writer, or bar code wand.

Power Connection Port

•On the lower right is a round port with a lock notch for securely connecting the terminal to a power source (identified by the “electrical power” icon at right).

Step 4: Connect the Terminal to a Telephone Line

Refer to Figure 4, page 11:

1.Direct connection — A telephone cord runs from the Telco port on the terminal directly to a telephone wall jack. With a direct connection, the line is dedicated to the terminal.

2.Pass-through connection — A telephone cord runs from the Telset port on the terminal to the RJ11-type jack on a standard telephone. With a pass-through connection, the line is busy during terminal downloads.

Caution: For the pass-through connection, do not lift the telephone handset during a transaction. Doing so may disrupt the carrier signal and cause the transaction to fail.

10