Unitech RS700 user manual Using the Hardware, Installing Wi-Fi Antenna

Page 14

Chapter 2

Using the Hardware

The RS700 contains two Antenna Ports for wireless signal enhancement and RFID reading points.

Installing Wi-Fi Antenna

There are two Wi-Fi Antenna Ports on the RS700 (Wi-Fi ANT1 and Wi-Fi ANT2). Install a Wi-Fi Antenna through the following:

1. Locate the Wi-Fi Antenna Ports on the RS700’s top panel.

2. Connect a Wi-Fi Antenna to a desired Wi-Fi Antenna Port, and rotate the antenna cap clockwise to secure the connection.

3. Bend the Wi-Fi Antenna(s) to a 90-degree angle.

DATA RFID PWR

GP I/0

BACKUP

SW

PWR+RS232

RESET

6

Copyright 2009 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.

Image 14

Contents RS700 Smart Rfid Fixed Reader Page Preface About This ManualFCC Caution Regulatory Compliance StatementsFederal Communication Commission Interference Statement FCC Radiation Exposure StatementStorage and Safety Notice Battery NoticesBattery Charge Notice Warranty Table of Contents Appendix a Introducing the RS700 FeaturesGetting Started Package Contents Component Description Tour of the RS700Front Panel Top Panel Bottom PanelConnect Power Using the Hardware Installing Wi-Fi AntennaInstalling Rfid Antenna Optional Pin Name Description Using the Gpio InterfaceGpio Pin Assignment Mounting the RS700 Performing a Hardware Reset Opening Smart-Reader Server Using Smart-Reader ServerMaking Rfid Applications Controlling Smart-Reader Server Remotely Installing Microsoft .NET FrameworkInstalling the Srsrc Program Using the Smart-Reader Server Remote Control Configuring Antenna Port Defining Smart Reader Behavior Creating a New EC Spec Start //spec1starttrigger Stop //spec1stoptrigger Specifying Report CriteriaDefining the EC Spec Urnepcpatgid-96*.*.* to match any GID-96 tagSubscribing the EC Spec Redefining the Subscription Viewing Data Collection Report Viewing Server Log Using the Application Programming InterfaceConnecting to BizTalk Server Making Rfid Applications Making Rfid Applications Check Add single device. Click Next Input the RS700s IP address and port number. Click Next Making Rfid Applications Making Rfid Applications Making Rfid Applications Connecting to Oracle Sensor Edge Server Click MyEdgeServer Click Change dispatcherMaking Rfid Applications Click Add new device Select Smart Reader Device Click MyEdgeServer → Groups → Default → RS700 Click Start all devices Obtaining an IP Address Advanced SettingsConnecting to a LAN Network Advanced Settings Setting the System TimeSetting up Ethernet connection Connecting to a Wlan Network Advanced Settings Advanced Settings Managing your Wireless Profiles Advanced Settings Advanced Settings Additional Capabilities Installing Microsoft ActiveSyncEstablishing Terminal-PC Connection Connecting the terminal to Your Computer Using Microsoft ActiveSync to Exchange Files On the computer, click My Computer → Mobile Device folderUsing Remote Control Click Start → Programs → ActiveSync Remote DisplayTroubleshooting Problem SolutionSystem Specification Appendix aSupport Region Web site