Unitech RS700 user manual Installing Rfid Antenna Optional

Page 15

Chapter 2 Using the Hardware

Installing RFID Antenna (Optional)

The RS700 has four RFID Antenna Ports (ANT1, ANT2, ANT3, and ANT4) and two removable protection caps on ANT2 and ANT3.

NOTE: Only remove the protective caps for installing RFID Antennas.

Install an RFID Antenna through the following:

1.Locate the RFID Antenna Ports on the RS700’s top panel.

2.If necessary, remove the protection caps on ANT2 and ANT3.

3.Connect the Antenna Cable to the desired RFID Antenna Port, and rotate the cable cap clockwise to secure the connection.

4.Connect the other end of the Antenna Cable to the wall mounted RFID Antenna, and rotate the cable cap clockwise to secure the connection.

NOTE: Refer to the RFID Antenna Installation guide for mounting the RFID Antenna(s).

WARNING! To avoid radiation exposure, the RFID Antennas should be installed and operated with minimum distance 1000mm away from the human body.

7

Image 15

Contents RS700 Smart Rfid Fixed Reader Page About This Manual PrefaceFCC Radiation Exposure Statement Regulatory Compliance StatementsFederal Communication Commission Interference Statement FCC CautionBattery Notices Battery Charge NoticeStorage and Safety Notice Warranty Table of Contents Appendix a Features Getting StartedIntroducing the RS700 Package Contents Tour of the RS700 Front PanelComponent Description Bottom Panel Top PanelConnect Power Installing Wi-Fi Antenna Using the HardwareInstalling Rfid Antenna Optional Using the Gpio Interface Gpio Pin AssignmentPin Name Description Mounting the RS700 Performing a Hardware Reset Using Smart-Reader Server Making Rfid ApplicationsOpening Smart-Reader Server Installing Microsoft .NET Framework Installing the Srsrc ProgramControlling Smart-Reader Server Remotely Using the Smart-Reader Server Remote Control Configuring Antenna Port Defining Smart Reader Behavior Creating a New EC Spec Specifying Report Criteria Start //spec1starttrigger Stop //spec1stoptriggerUrnepcpatgid-96*.*.* to match any GID-96 tag Defining the EC SpecSubscribing the EC Spec Redefining the Subscription Viewing Data Collection Report Using the Application Programming Interface Connecting to BizTalk ServerViewing Server Log Making Rfid Applications Making Rfid Applications Check Add single device. Click Next Input the RS700s IP address and port number. Click Next Making Rfid Applications Making Rfid Applications Making Rfid Applications Click MyEdgeServer Click Change dispatcher Connecting to Oracle Sensor Edge ServerMaking Rfid Applications Click Add new device Select Smart Reader Device Click MyEdgeServer → Groups → Default → RS700 Click Start all devices Advanced Settings Connecting to a LAN NetworkObtaining an IP Address Setting the System Time Advanced SettingsSetting up Ethernet connection Connecting to a Wlan Network Advanced Settings Advanced Settings Managing your Wireless Profiles Advanced Settings Advanced Settings Installing Microsoft ActiveSync Establishing Terminal-PC ConnectionAdditional Capabilities Connecting the terminal to Your Computer On the computer, click My Computer → Mobile Device folder Using Microsoft ActiveSync to Exchange FilesClick Start → Programs → ActiveSync Remote Display Using Remote ControlProblem Solution TroubleshootingAppendix a System SpecificationRegion Web site Support