Unitech RS700 user manual Configuring Antenna Port

Page 22

Chapter 3 Making RFID Applications

NOTE: Do not change the default port number from 11126, and ensure that the port is not occupied by any other service.

3.The SRS Remote Control window appears. The SRSRC menu resides in the left pane, while the reader status is in the right pane.

At the bottom right corner of the screen, the login info displays the user name and the login time duration. Click Stop to end the connection between the RS700 and the R1000 Reader.

NOTE: A dialog box appears informing User account expired! (when the screen is idle for three minutes). Login (again) and continue with the set- tings.

Configuring Antenna Port

To enable or disable antennas connected to antenna ports, click Device Status in the left screen panel. Configure the Antenna Port settings through the following:

1.In the Antennas: field, check the antenna port number to enable the antenna. Antenna port number (1 is checked by default). If more than one antenna is enabled, the antennas switch in numerical order (i.e., 1 → 2 → 3 → 4 → 1).

2.In the Antenna Switch Time (ms): field, input the Antenna Switch Time for each reading period (300ms by default).

14

Copyright 2009 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.

Image 22

Contents RS700 Smart Rfid Fixed Reader Page Preface About This ManualFCC Caution Regulatory Compliance StatementsFederal Communication Commission Interference Statement FCC Radiation Exposure StatementBattery Charge Notice Battery NoticesStorage and Safety Notice Warranty Table of Contents Appendix a Getting Started FeaturesIntroducing the RS700 Package Contents Front Panel Tour of the RS700Component Description Top Panel Bottom PanelConnect Power Using the Hardware Installing Wi-Fi AntennaInstalling Rfid Antenna Optional Gpio Pin Assignment Using the Gpio InterfacePin Name Description Mounting the RS700 Performing a Hardware Reset Making Rfid Applications Using Smart-Reader ServerOpening Smart-Reader Server Installing the Srsrc Program Installing Microsoft .NET FrameworkControlling Smart-Reader Server Remotely Using the Smart-Reader Server Remote Control Configuring Antenna Port Defining Smart Reader Behavior Creating a New EC Spec Start //spec1starttrigger Stop //spec1stoptrigger Specifying Report CriteriaDefining the EC Spec Urnepcpatgid-96*.*.* to match any GID-96 tagSubscribing the EC Spec Redefining the Subscription Viewing Data Collection Report Connecting to BizTalk Server Using the Application Programming InterfaceViewing Server Log Making Rfid Applications Making Rfid Applications Check Add single device. Click Next Input the RS700s IP address and port number. Click Next Making Rfid Applications Making Rfid Applications Making Rfid Applications Connecting to Oracle Sensor Edge Server Click MyEdgeServer Click Change dispatcherMaking Rfid Applications Click Add new device Select Smart Reader Device Click MyEdgeServer → Groups → Default → RS700 Click Start all devices Connecting to a LAN Network Advanced SettingsObtaining an IP Address Advanced Settings Setting the System TimeSetting up Ethernet connection Connecting to a Wlan Network Advanced Settings Advanced Settings Managing your Wireless Profiles Advanced Settings Advanced Settings Establishing Terminal-PC Connection Installing Microsoft ActiveSyncAdditional Capabilities Connecting the terminal to Your Computer Using Microsoft ActiveSync to Exchange Files On the computer, click My Computer → Mobile Device folderUsing Remote Control Click Start → Programs → ActiveSync Remote DisplayTroubleshooting Problem SolutionSystem Specification Appendix aSupport Region Web site