Unitech RS700 user manual Performing a Hardware Reset

Page 18

Chapter 2 Using the Hardware

Performing a Hardware Reset

Perform a reset if the RS700 freezes (i.e., no longer responds).

Resetting the RS700 erases all installed records, entries and programs; returning the RS700 to default status. (Not even the date and time settings remain.) All settings return to default mode. However, data stored in the flash storage or in an SD Card Slot will remain intact. Use the remote control to access the SD folder on the RS700. See Using Remote Control on page 47.

NOTE: During the next Microsoft ActiveSync operation, lost data can be restored that was previously synchronized on the computer, or data can be restored from a storage card.

Reset the RS700 through one of the following:

1.Use a stylus to press the reset button on the RS700’s bottom panel.

2.Reconnect the power supply, and reset the Backup Battery Switch to the on position.

CAUTION! Pressing the Reset Button erases current configuration settings and reboots the RS700. The RS700 returns to default mode. All registry settings and all files (including hidden files) are returned to their origi- nal factory defaults.

10

Copyright 2009 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.

Image 18

Contents RS700 Smart Rfid Fixed Reader Page Preface About This ManualFCC Caution Regulatory Compliance StatementsFederal Communication Commission Interference Statement FCC Radiation Exposure StatementBattery Notices Battery Charge NoticeStorage and Safety Notice Warranty Table of Contents Appendix a Features Getting StartedIntroducing the RS700 Package Contents Tour of the RS700 Front PanelComponent Description Top Panel Bottom PanelConnect Power Using the Hardware Installing Wi-Fi AntennaInstalling Rfid Antenna Optional Using the Gpio Interface Gpio Pin AssignmentPin Name Description Mounting the RS700 Performing a Hardware Reset Using Smart-Reader Server Making Rfid ApplicationsOpening Smart-Reader Server Installing Microsoft .NET Framework Installing the Srsrc ProgramControlling Smart-Reader Server Remotely Using the Smart-Reader Server Remote Control Configuring Antenna Port Defining Smart Reader Behavior Creating a New EC Spec Start //spec1starttrigger Stop //spec1stoptrigger Specifying Report CriteriaDefining the EC Spec Urnepcpatgid-96*.*.* to match any GID-96 tagSubscribing the EC Spec Redefining the Subscription Viewing Data Collection Report Using the Application Programming Interface Connecting to BizTalk ServerViewing Server Log Making Rfid Applications Making Rfid Applications Check Add single device. Click Next Input the RS700s IP address and port number. Click Next Making Rfid Applications Making Rfid Applications Making Rfid Applications Connecting to Oracle Sensor Edge Server Click MyEdgeServer Click Change dispatcherMaking Rfid Applications Click Add new device Select Smart Reader Device Click MyEdgeServer → Groups → Default → RS700 Click Start all devices Advanced Settings Connecting to a LAN NetworkObtaining an IP Address Advanced Settings Setting the System TimeSetting up Ethernet connection Connecting to a Wlan Network Advanced Settings Advanced Settings Managing your Wireless Profiles Advanced Settings Advanced Settings Installing Microsoft ActiveSync Establishing Terminal-PC ConnectionAdditional Capabilities Connecting the terminal to Your Computer Using Microsoft ActiveSync to Exchange Files On the computer, click My Computer → Mobile Device folderUsing Remote Control Click Start → Programs → ActiveSync Remote DisplayTroubleshooting Problem SolutionSystem Specification Appendix aSupport Region Web site