Uniden BCT8 manual Fleet Map Programming, Selecting Preset Fleet Map, Programming a User Fleet Map

BCT8 8/13/03 5:14 PM Page 44

Fleet Map Programming

If you have programmed a trunk tracking bank for Motorola, press TRUNK to start Multi- Track, and you will see user IDs on the display. Since the BCT8 defaults to Type II systems, all the IDs will appear as numbers. However, if you notice a mix of odd and even user IDs, for example 6477, 2560, 6481, 6144, 1167, etc., then you are probably monitoring either a Type I or Hybrid systems.

You may also notice that you are missing responses when you hold on an active ID. Unlike Type II, Type I/Hybrid systems require a Fleet Map that sets specific Fleet-Subfleet parameters. It is easy to select a Fleet Map for your scanner; what is not always easy is selecting or programming a map that matches your particular area.

There are 16 preset Fleet Maps listed in the Appendix that you can choose, and these are usually a good place to start when setting up a Type I/Hybrid trunk tracking bank. If you choose a preset map and still have difficulty following complete conversations, then you'll have to program your own Fleet Map.

Selecting Preset Fleet Map

1.Press and hold TRUNK for 1.5 seconds and select the bank you want to change.

2.Use the ▲ or ▼ key to select (Type 1 system), then press E.

3.Use the ▲ or ▼ key to select , then press E.

4. Use the ▲ or ▼ key to select the map you want, then press E. The scanner returns to FLEET Map list item.

Note: You will now begin to see Type I Fleet-Subfleet IDs. For example, 100-12, 100-9, 000-12, 400-8, etc.

See "User Defined Fleet Maps in the Appendix" for more information about Type I IDs.

How do you know if the preset map is correct? You will have to listen to see if you're following complete conversations. If not, you should try another preset map.

Programming a User Fleet Map

You may want to read "User Defined Fleet Maps" in the Appendix before programming a Fleet Map. It contains a detailed explanation of Scanner Fleet Map Programming, as well as a table listing the Fleet Map Size Codes.

1.Press and hold TRUNK for 1.5 seconds and select the bank you want to change.

2.Use the ▲ or ▼ key to select (Type 1 system), then press

E.

3. Use the ▲ or ▼ key to select , then press E.

4. Use the ▲ or ▼ key to select , then press E.

5. Use the ▲ or ▼ key to select the size code for the first block, then press E.

44