Uniden UBC72XLT owner manual Chain Search Hold Mode

Page 38

Press 0-9to enable or disable the search bank number being searched in this mode. Enabled bank numbers appear. (Disabled bank numbers disappear).

At least one search bank must be enabled. (The scanner sounds an error tone if you try to disable all the search banks). The search bank and the frequency where chain search starts depends on how the scanner was set before you selected chain search mode.

Chain Search Hold Mode

To start chain search hold mode, press Hold in chain search mode. The scanner stops searching and Hold appears. In this mode, pressing

Func + changes the search direction downward and pressing Func + changes the search

direction upward. or appears according to the current search direction.

Storing Frequencies Found During Chain Search into Channel Memory

You can store frequencies you find in chain search mode or chain search hold mode.

1.Press Func + Pgm in chain search mode or chain search hold mode. The lowest blank channel and bank appear.

2.Press E to store the frequency into the blank channel. To select another channel, press Func + or Func + before you press E. You can also press 0-9 to select the bank.

If you try to save a frequency that is already stored, the scanner sounds an error tone and displays the channel that was duplicated. If you entered the fre- quency by mistake, press . To enter the frequency anyway, press E to accept.

Special Features

38

Image 38

Contents UBC72XLT Scanner Precautions PrecautionsUBC72XLT Controls and Display UBC72XLT Controls and DisplayContents Contents Introduction IntroductionFrequency Range Step Mode Transmission MHz KHz Feature Highlights Feature HighlightsAbout This Manual Feature Highlights Understanding Scanning What is Scanning?What is Searching? Conventional ScanningSimplex Operation Repeater OperationWhere To Obtain More Information Information On The InternetIncluded With Your Scanner Included With Your ScannerUsing Non-Rechargeable Batteries Setting Up Your ScannerUsing Internal Batteries Setting Up Your ScannerSetting Up Your Scanner Page Setting Up Your Scanner Using AC Power Connecting the AntennaConnecting an Optional Antenna Connecting an Earphone/HeadphoneConnecting an Extension Speaker Attaching the Belt Clip About Your Scanner About Your ScannerLook At The Keypad HoldFunc + Pgm Look At The Display About Your Scanner Channel-Storage Banks Service BanksUnderstanding Banks Storing Known Frequencies Into Channels Turning On The Scanner Setting SquelchOperation OperationService Search Searching For and Temporarily Storing Active FrequenciesStoring Frequencies into Channels During Service Search Scanning the Stored ChannelsManually Selecting a Channel Close CallTM RF Capture Technology Special FeaturesSpecial Features Setting the Close Call Options Special Features Using Close Call RF Capture Chain Search Mode Chain SearchChain Search Hold Mode Setting the Search Range Direct Entry SearchDirect Entry Search Hold Mode Search Skip Memory Delay Turning Channel-Storage Banks On and Off Locking Out Channels PriorityUsing Keylock Using the Display BacklightTroubleshooting TroubleshootingTroubleshooting Resetting the Scanner Care and Maintenance Care and MaintenanceCleaning General UseRepairs BirdiesSpecifications SpecificationsSeconds Optional Accessories Optional AccessoriesOne Year Limited Warranty One-Year Limited WarrantyUniden Australia PTY Limited Service Division Thank YOU for Buying a Uniden Product