Uniden UBC72XLT owner manual Using AC Power, Connecting the Antenna

Page 19

Using AC Power

You can power the scanner using an optional 6V, 500 mA AC adapter.

To use the scanner on AC power, plug the AC adapter into DC 6V on the side of the scanner then plug the other end into a standard AC outlet.

If rechargeable batteries are installed and

REG. ALK. BATT./NI-MH BATT. is set to NI-MH BATT., the adapter powers the scanner and recharges the installed batteries at the same time.

Connecting the Antenna

To attach the supplied flexible antenna to the connector on the top of your scanner, align the slots around the antenna's connector with the tabs on the scanner's BNC connector. Then slide the antenna's connector down over the scanner's connector and rotate the antenna connector's outer ring clockwise until it locks into place.

Setting Up Your Scanner

19

Image 19

Contents UBC72XLT Scanner Precautions PrecautionsUBC72XLT Controls and Display UBC72XLT Controls and DisplayContents Contents Introduction IntroductionFrequency Range Step Mode Transmission MHz KHz Feature Highlights Feature HighlightsAbout This Manual Feature Highlights Conventional Scanning What is Scanning?What is Searching? Understanding ScanningRepeater Operation Simplex OperationInformation On The Internet Where To Obtain More InformationIncluded With Your Scanner Included With Your ScannerSetting Up Your Scanner Setting Up Your ScannerUsing Internal Batteries Using Non-Rechargeable BatteriesSetting Up Your Scanner Page Setting Up Your Scanner Connecting the Antenna Using AC PowerConnecting an Extension Speaker Connecting an Earphone/HeadphoneConnecting an Optional Antenna Attaching the Belt Clip About Your Scanner About Your ScannerHold Look At The KeypadFunc + Pgm Look At The Display About Your Scanner Understanding Banks Service BanksChannel-Storage Banks Operation Turning On The Scanner Setting SquelchOperation Storing Known Frequencies Into ChannelsSearching For and Temporarily Storing Active Frequencies Service SearchScanning the Stored Channels Storing Frequencies into Channels During Service SearchManually Selecting a Channel Special Features Special FeaturesClose CallTM RF Capture Technology Setting the Close Call Options Special Features Using Close Call RF Capture Chain Search Chain Search ModeChain Search Hold Mode Direct Entry Search Setting the Search RangeDirect Entry Search Hold Mode Search Skip Memory Delay Turning Channel-Storage Banks On and Off Priority Locking Out ChannelsUsing the Display Backlight Using KeylockTroubleshooting TroubleshootingTroubleshooting Resetting the Scanner General Use Care and MaintenanceCleaning Care and MaintenanceBirdies RepairsSpecifications SpecificationsSeconds Optional Accessories Optional AccessoriesOne-Year Limited Warranty One Year Limited WarrantyUniden Australia PTY Limited Service Division Thank YOU for Buying a Uniden Product