Scanning Preprogrammed Races
Before You Get To The Track
Each driver’s team has several different frequencies they can use during a race. These frequencies can change depending on local interference sources or other frequency issues. Your scanner is preprogrammed with all of the drivers and their possible frequencies that were known when it was manufactured.
Before you leave for the track, check the Internet to see if there are any frequency updates available for your race. You can save time at the track by setting up as much as possible before you leave.
When You Get To The Track
When you arrive at the race, get a list of the actual fre- quencies in use that race day. These are normally avail- able for sale on the way into the facility. This list will show the actual frequency being used by each driver that day, as well as some other useful frequency information. Then, follow the steps in the sections below to adjust the scanner settings.
Selecting Driver Frequencies
Follow these steps to select the appropriate frequency for each driver.
1.Press 0, rotate the scroll control to select the race, then press E.
2.Press CAR, enter the driver’s number, press E or CAR, press E, rotate the scroll control to select the driver, then press E.
3.Rotate the scroll control to select the driver’s frequency. If the driver’s frequency is not listed, select NEW Frequency then enter the correct frequency.
4.Press Hold to set the selection.
Basic Operation
35