Uniden UBC92XLT Setting Up Your Scanner, Using Internal Batteries, Using Rechargeable Batteries

Page 15

UB324 Paper OM reduced size.fm Page 15 Wednesday, February 2, 2005 8:01 PM

Setting Up Your Scanner

These guidelines will help you install and use your new scanner:

•If your scanner receives interference or electrical noise, move the scanner or its antenna away from the source.

•To improve the scanner’s reception, use an optional external antenna designed for multi- band coverage. (You can purchase this type of antenna at a local electronics store). If the optional antenna has no cable, use 50-70 ohm coaxial cable for lead-in. A mating plug might be necessary for the optional antennas.

•Use an optional mono earphone or mono headset with proper impedance for private listening. Read the precautions on the inside front cover of this Owners Manual.

•Do not use the scanner in high-moisture environments such as the kitchen or bathroom.

•Avoid placing the scanner in direct sunlight or near heating elements or vents.

Using Internal Batteries

You can power your scanner using supplied rechargeable AA batteries.

Using Rechargeable Batteries

Before you use Ni-MH or Ni-Cd batteries, you must charge them.

The scanner has a built-in circuit that lets you recharge Ni-MH or Ni-Cd batteries while they are in the scanner. To charge the batteries;

1.Make sure the power is turned off.

2.Slide the battery compartment cover.

Setting Up Your Scanner

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents
UB324hyou1.eps A N N E RPrecautions PrecautionsUBC92XLT Controls and Display UBC92XLT Controls and DisplayContents Contents Introduction IntroductionBand Plan Mode Step Feature Highlights Feature HighlightsAbout This Manual Conventional Scanning What is Scanning? What is Searching? Understanding ScanningRepeater Operation Simplex OperationInformation On The Internet Where To Obtain More InformationIncluded With Your Scanner Included With Your ScannerSetting Up Your Scanner Setting Up Your ScannerUsing Internal Batteries Using Rechargeable BatteriesUsing Non-rechargeable Batteries Setting Up Your Scanner Connecting the Antenna Using AC PowerConnecting an Earphone/Headphone Connecting an Extension SpeakerConnecting an Optional Antenna Attaching the Belt Clip About Your Scanner About Your ScannerLook At The Keypad Func + Step Look At The Display Service Banks Understanding BanksChannel-Storage Banks Operation Turning On The Scanner Setting SquelchOperation Storing Known Frequencies Into ChannelsSearching For and Temporarily Storing Active Frequencies Service SearchScanning the Stored Channels Storing Frequencies into Channels During Service SearchManually Selecting a Channel Special Features Special FeaturesChain Search Chain Search Mode Setting the Search Range Chain Search Hold ModeDirect Entry Search Direct Entry Search Hold Mode Search Skip Memory Delay Turning Channel-Storage Banks On and Off Priority Locking Out ChannelsUsing the Display Backlight Using KeylockTroubleshooting TroubleshootingTroubleshooting Resetting the Scanner General Use Care and MaintenanceCleaning Care and MaintenanceBirdies RepairsSpecifications Specifications21.3 MHz Optional Accessories Optional AccessoriesDeclaration of Conformity Declaration of ConformityMemo Memo UBZZ01324BZ
Top Page Image Contents