Uniden UBC92XLT manual Setting Up Your Scanner

Page 17

UB324 Paper OM reduced size.fm Page 17 Wednesday, February 2, 2005 8:01 PM

Cautions:

•Use only fresh batteries of the required size and recommended type.

•Always remove old or weak batteries. Batteries can leak chemicals that destroy electronic circuits.

•Do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable), or rechargeable batteries of different capacities.

WARNING!

Do not connect either adapter to the scanner if non- rechargeable batteries (such as alkaline batteries) are installed in the scanner and REG. ALK. BATT./ NI-MH BATT. is set to NI-MH BATT (this is the default setting with the sticker) or if you are unsure of the switch’s position. Non-rechargeable batteries will get hot and can even burst if you try to recharge them.

Before you use Ni-MH or Ni-Cd batteries for the first time, charge them for 16 hours to bring them to a full charge. Discharged batteries take about 16 hours to fully recharge.

Notes:

•Ni-MH batteries last longer and deliver more power if you occasionally let them fully discharge. To do this, simply use the scanner

until it beeps every 15 seconds and flashes.

•To prevent damage to Ni-MH batteries, never charge them in an area where the temperature is above 113°F (45°C) or below 40°F (4°C).

Setting Up Your Scanner

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents
UB324hyou1.eps A N N E RPrecautions PrecautionsUBC92XLT Controls and Display UBC92XLT Controls and DisplayContents Contents Introduction IntroductionBand Plan Mode Step Feature Highlights Feature HighlightsAbout This Manual What is Searching? What is Scanning?Understanding Scanning Conventional ScanningRepeater Operation Simplex Operation Information On The Internet Where To Obtain More InformationIncluded With Your Scanner Included With Your ScannerUsing Internal Batteries Setting Up Your ScannerUsing Rechargeable Batteries Setting Up Your ScannerUsing Non-rechargeable Batteries Setting Up Your Scanner Connecting the Antenna Using AC PowerConnecting an Optional Antenna Connecting an Earphone/HeadphoneConnecting an Extension Speaker Attaching the Belt Clip About Your Scanner About Your ScannerLook At The Keypad Func + Step Look At The Display Channel-Storage Banks Service BanksUnderstanding Banks Operation Turning On The Scanner Setting SquelchStoring Known Frequencies Into Channels OperationSearching For and Temporarily Storing Active Frequencies Service SearchScanning the Stored Channels Storing Frequencies into Channels During Service SearchManually Selecting a Channel Chain Search Special FeaturesSpecial Features Chain Search Mode Setting the Search Range Chain Search Hold ModeDirect Entry Search Direct Entry Search Hold Mode Search Skip Memory Delay Turning Channel-Storage Banks On and Off Priority Locking Out ChannelsUsing the Display Backlight Using KeylockTroubleshooting TroubleshootingTroubleshooting Resetting the Scanner Cleaning Care and MaintenanceCare and Maintenance General UseBirdies RepairsSpecifications Specifications21.3 MHz Optional Accessories Optional AccessoriesDeclaration of Conformity Declaration of ConformityMemo Memo UBZZ01324BZ
Top Page Image Contents