Network deployment

Setup the Network Camera over the Internet

This section explains how to configure the Network Camera to an Internet connection.

1.If you have external devices such as sensors and alarms, make connection from general I/O terminal block.

2.Use the supplied RJ45 female/female coupler to connect the Network Camera to a network port via an Ethernet cable. Use Category 5 Cross Cable when the Network Camera is directly connected to a PC.

3.Connect the power cord socket from the Network Camera to the supplied AC adapter.

Introduction

1 2

3

Ethernet switch/router (not supplied)

1485B

485A AC24V AC24V

GND DI DO +12V N.C.

N.C.: No connection

485B: RS485-

485A: RS485+

AC24V: 24 VAC Power Input

AC24V: 24 VAC Power Input

GND: Ground

DI : Digital Input

DO : Digital Output

+12V : 12 VDC Output

Installation

There are three ways to setup the Network Camera over the Internet. The first way is to setup the Network Camera behind a gateway. The second way is to utilize a static IP. The third way is to use PPPoE.

Internet connection via a gateway

Before setting up the Network Camera over the Internet, make sure you have a gateway and follow the steps below.

1.Connect your Network Camera behind a gateway, a network environment example is illustrated as below. Regarding how to get your IP address, refer to Software installation on page 18 for details.

WAN (Wide Area Network)

Router IP address : from ISPIP address : 192.168.0.3

Subnet mask : 255.255.255.0

Default gateway : 192.168.0.1

LAN (Local Area Network)

Router IP address : 192.168.0.1

Cable or DSL Modem

IP address : 192.168.0.2

Subnet mask : 255.255.255.0

Default gateway : 192.168.0.1

㪋㪇㩷㪆㩷㪈㪍㪇

How to Use

Definitions

Configuration

Appendix

15

Page 15
Image 15
Toshiba IK-WB70A manual Network deployment, Setup the Network Camera over the Internet, Internet connection via a gateway