Set up the Network Camera through Power over Ethernet (PoE)

When using a PoE hub

The Network Camera is PoE-compliant, which allows it to be powered via a single Ethernet cable. If your hub or gateway supports PoE, refer to the following illustration to connect the Network Camera to a PoE hub/gateway via an Ethernet cable.

power + data transmission

PoE hub

(not supplied)

When using a non-PoE hub

If your hub or gateway does not support PoE, use a PoE power injector (not supplied) to connect between the Network Camera and a non-PoE hub or gateway.

PoE power injector (not supplied)

non-PoE hub (not supplied)

Introduction

Installation

How to Use

Definitions

Configuration

Appendix

㪋㪉㩷㪆㩷㪈㪍㪇

17

Page 17
Image 17
Toshiba IK-WB70A Set up the Network Camera through Power over Ethernet PoE, When using a PoE hub, When using a non-PoE hub