Troubleshooting
Status LED
The LED indicates the status of the Network Camera.
Status LED | Description | |
Blinking red | 1. | Power is being supplied to the Network Camera. |
(two short, one long) | 2. | Restore, or reboot the Network Camera. |
|
|
|
Introduction
Reboot and restore
Reset button
Status LED
There is a reset button on the inner side of the Network Camera. It is used to reboot the Network Camera or restore the Network Camera to factory default. Sometimes rebooting the Network Camera could set the Network Camera back to normal state. If the problems remain after rebooting, restore the Network Camera to factory default and install again.
Reboot: Press and release the reset button. The status LED will blink two short one long in red.
Restore: Press the reset button continuously for over 5 seconds until the status LED blinks two short one long in red. Note that all settings will be restored to factory default.
Restoring the factory defaults will erase any previous settings.
Audio
When using multiple network cameras, restart Internet Explorer each time you switch the camera. Using the same Internet Explorer for the multiple cameras may transmit multiple camera's audio.
㪐㪍㩷㪆㩷㪈㪍㪇
Installation
How to Use
Configuration Definitions
Appendix
71
