Using 3GPP-compatible mobile devices

To view the streaming media through 3GPP-compatible mobile devices, make sure the Network Camera can be accessed from the Internet. For more information on how to set up the Network Camera over the Internet, refer to Setup the Network Camera over the Internet on page 15.

To utilize this feature, check the following settings on your Network Camera:

1.Because most players on 3GPP mobile phones do not support RTSP authentication, make sure the authentication mode of RTSP streaming is set to disable. For more information, refer to RTSP Streaming on page 41.

2.As the 3G network bandwidth is limited, you can not use large video size. Set the video and audio streaming parameters as listed below.

For more information, refer to Audio and video on page 45.

Video Mode

MPEG-4

Frame size

176 x 144

Maximum frame rate

5 fps

Intra frame period

1 S

Video quality (Constant bit rate)

40 kbps

Audio type (GSM-AMR)

12.2 kbps

3.As most ISP and players only support port number 554 to allow RTSP streaming to go through, set the RTSP port to 554.For more information, refer to RTSP Streaming on page 41.

4.Launch the players on 3GPP-compatible mobile devices. Type the URL commands in the player.

The format is rtsp://<public ip address of your camera>:<rtsp port>/<access name for stream1 or stream2>.

Introduction

Installation

How to Use

Definitions

Configuration

Appendix

㪋㪍㩷㪆㩷㪈㪍㪇

21

Page 21
Image 21
Toshiba IK-WB70A manual Using 3GPP-compatible mobile devices, MPEG-4