Uniden Data 2000 Wireless CDPD PC Card manual Using Windows 98 Dial-Up Networking

▲Uniden Data 2000 Wireless CDPD PC Card

2.6Using Windows 98 Dial-Up Networking

To use your Uniden Data 2000 modem with Windows 98 Dial-up Networking, take the following steps:

2.6.1 Checking Dial-Up Networking Installation

To determine if dial-up networking is already installed, double-click on the My Computer icon. If you don't see an icon for Dial-Up Networking, you will need to add this feature:

2.6.2 Installing Dial-Up Networking.

If Dial-up networking is not installed, follow these steps:

Note: It is possible that Windows 98 setup software will be required for installation.

1.Click on the My Computer icon.

2.Select Control Panel.

3.Select Add/Remove Programs.

4.Select Windows Setup tab.

5.Select Communication.

6.Check the Dial-Up Networking box, then click OK.

Depending on your preference, or the host configuration, you can use SLIP or PPP Dial-up Networking to interface with the host computer. For SLIP, see Section 2.6.3. For PPP see Section 2.6.4.

2.6.3Installing Windows 98 Support for SLIP

1.Click on the My Computer icon.

2.Select Control Panel.

3.Select Add/Remove Programs.

4.Select the Windows Setup tab.

5.Insert a floppy disk or CD-ROM with rnaplus.inf. Click Have Disk.

6.Check the file path. Click OK.

7.Check the box for Unix Connection for Dial-Up

Networking then click Install.

Uniden Data 2000 Installation and Operation Manual 2-25