▲Uniden Data 2000 Wireless CDPD PC Card
D.5 AT Commands/Reading the Configuration
AT Command Syntax | Description of Command |
|
|
AT ACTNEI? | Read the current Active IP address from the |
| System Table. |
| Response: NEI n ddd.ddd.ddd.ddd |
AT BOOTVER? | Read the version of the boot code from |
| the System Table. |
| Response: Boot n.n (X) (Date Time) |
|
|
AT CDPDVER? | Read the CDPD version supported by this |
| modem from the System Table. |
| (Currently 1.1 is the only |
| version supported.) |
| Response: CDPD Version 1.1 |
AT CMPR? | Read Data Compression Mode from |
[CAT] [MDT][UDT][SPDT] | a particular default table. |
| Response: Header Compression Flag 0 or |
| Header Compression Flag 1 |
| (If the option is not specified, the modem |
| will read the Baud rate from the CAT.) |
| Header Compression O means Header |
| Compression is off, Header Compression 1 |
| means Header Compression is on. |
|
|
AT ECHO? | Read Echo mode from the System Table. |
| Response: Echo 0 or Echo 1 |
| Echo 0 means Echo is off, Echo 1 means |
| Echo is on. |
|
|
AT EID? | Read the EID programmed in the Modem |
| from the System Table. |
| Response: EID Parameter xxxxxxxxxxxx |
| (x = hexadecimal) |
|
|