Rear View Details
∙Reset Button: Pressing this button once performs a soft reboot, similar to turning the power on and off. However, if you press and hold the button for approximately 10 seconds, the device will reset to the factory default settings, erasing any configuration changes you have made (including the password).
∙Ports 1 through 4: These
∙WAN Port:
∙7.5V Power Jack: Connects to the Uniden supplied external power adapter to the power jack.
13
Quick Installation Process
There are three steps to install your 10/100 Ethernet Router and create a your own Local Area Network (LAN).
1.Hardware Installation: Through this process you will physically connect your computers to your router.
2.PC Configuration: For each computer, you will need to make sure they have the same LAN IP Address (The LAN IP Address is similar to an area code for making telephone calls. In order for all the computers to talk to each other, they must reside in the same area code).
3.Basic Router Configuration: Within this step you can set your Parental Controls, Passwords, and other features of your 10/100 Router.
STEP 1: HARDWARE INSTALLATION
NOTE: During the hardware installation process, please make sure all computers and the router are turned off until the installation process is complete.
Before installing the ENR1504 you will need the following:
∙One external DSL or Cable modem with an Ethernet Port.
∙Network Cables with
∙TCP/IP network protocols installed on all PCs. (See page 85 if you need assistance)
14