When the scanner is staying on a frequency, “- - - - -
Close Call Operation
1.When a signal is detected, the scanner alerts (depending on the Set Close Call Alert setting, page 20) and immediately jumps to the Close Call frequency. But, the frequency is not displayed.
NOTE: Close Call does not work during selecting the band search, selecting the State code and programming mode.
If you want to confirm the frequency, press any key.
Even if a signal is lost, the scanner stops at this frequency for 10 seconds (if delay is on). After 10 seconds, the scanner resumes previous scanning.
2.If you press HOLD during the transmission or the delay time, the Scanner enters Close Call Hold mode and stays on the frequency.
During the hold mode, the scanner does not check any other signal.
3.Press HOLD to resume the signal searching.
4a. If you press HOLD while the scanner is searching the signal, the scanner stops the and displays the current search Band.
b.Press 
or 
to select the searching band.
c.If you press L/O, you can set search skip frequency.
d.To clear all the skip frequencies, hold L/O for over 2 seconds.