Uniden BC-RH96 manual Initialize Memory Reset

Page 25
#NN/GOQT[%NGCT 2NGCUG9CKV

Initialize Memory (Reset)

To reset the BC-RH96 to factory default settings, follow the sequence below. Note that once done, there is no undo and all programmed keys are reset.

With the unit off, press and hold the following keys and turn on power at the same time: [2], [9] and [HOLD].You see the reset screen below.

If you turn off power during reset, the process starts again when you next turn on the unit.

Using the Cable Clamp A self-adhesive clamp/ guide is provided to

assist you to safely route the Remote Cable to your target scanner.

Clean the planned location, peel the base

covering, and firmly press it on the scanner.

Then route the Remote Cable through the guide. This helps assure that the remote Cable will not come out of the special connector on either a Mobile of Handy scanner.

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Page Table of Contents Introduction FCC Statement IC Statement Included with your BC-RH96 Mounting the BC-RH96 Using the Mounting BracketBC-RH96 Using Hook and Loop Material BC-RH96 Connections Remote Head and Scanner Power Connecting CablesControl Cable Data Port Cable Firmware Updates Control Configuration Guides BCD396T Key Configuration BR330T Key ConfigurationBCD996T Key Configuration BCT15 Key Configuration8GTUKQP  Operation2QYGTKPI FQYP  Setting the BC-RH96 BacklightSetting the BC-RH96 LCD Contrast Configuration Menu ModeMobile Default Key Assigment Setting Mobile OptionsF1, F2, F3 Key Function Default Handy Option Key Assigment Setting Handy OptionsSetting Hold Timer Setting the Function ModeVolume Settings For Handy Scanner Setting Auto ReleaseMiscellaneous Control Limitations Serial Operation PrecautionsInitialize Memory Reset One Year Limited Warranty Specifications
Top Page Image Contents