XiNCOM XC-DPG602 manual Operation & Status Overview, System Status

XC-DPG602

Twin WAN DNS → IP Gateway

Chapter Contents

•System Status

•Restore Factory Defaults

•WAN Status

•LAN Status

Chapter 9 - Operation & Status

Operation & Status Overview

Once both the XC-DPG602 and the PCs are configured, operation is automatic. However, there are some situations where additional Internet configuration may be required (Refer to Chapter 4 - Advanced Features for

further details)

System Status

WAN Information	Connection Status – Current status – either “Connected” or “Not connected”.
	Connection Type – The type of connection used – DHCP, Fixed IP, PPPoE, or PPTP.
	Force Renew button– Only available when using a dynamic IP address (DHCP). Clicking this button will perform a DHCP
	“Renew” transaction with the ISP’s DHCP server. This will extend the period for which the current WAN IP address is
	allocated to you.
	IP Address – The IP address of the XC-DPG602 when seen from the Internet. This IP Address is allocated by the ISP
	(Internet Service Provider).
	Subnet Mask – The Network Mask (Subnet Mask) for the IP Address above.
	Domain Name IP Address – The address of the current DNS (Domain Name Server).
	MAC Address – The MAC (physical) address of the XC-DPG602 when seen from the Internet.
LAN Information	IP Address – The LAN IP Address of the XC-DPG602.
	Subnet Mask – The Network Mask (Subnet Mask) for the IP Address above.
	MAC Address – The MAC (physical) address of the XC-DPG602 when seen from the local LAN.
	DHCP Server – The status of the DHCP Server function - either “Enabled” or “Disabled”.
Device Information	Firmware Version – Version of the Firmware currently installed.
	NAT – Status of the NAT feature – either “Enable” or “Disable”.
	Load Balance – Status of the Load Balance feature – either “Enable” or “Disable”.
	Virtual Server – Status of the Virtual Server feature – either “Enabled” or “Disabled”.
	Special Applications – Status of the Special Applications feature – either “Enabled” or “Disabled”.
	DMZ – Status of the DMZ feature – either “Enabled” or “Disabled”.
	Block URL – Status of the Block URL feature – either “Enable” or “Disable”.
	Hardware ID – The manufacturers ID for this particular device.
Device Statistics	System UpTime – The time since the system of a device was last re-initialized.
	CPU Usage – The current usage percentage of CPU.
	Memory Usage – The current usage percentage of Memory (Heap & Queue).
Buttons	Refresh – Update the data on screen.
	Restart – Restart (reboot) the XC-DPG602.	43
	Restore Factory Defaults – This will delete all existing settings, and restore the factory default settings.