XiNCOM XC-DPG602 manual LED Action Condition, Default Settings

Physical Details

Front Panel Status and Error conditions

LED Action	Condition
WAN1 LINK/ACT & 10M/100M LEDs flash alternatively.	Firmware Download in progress.
WAN1 LINK/ACT & 10M/100M LEDs flash concurrently.	MAC address not assigned.
WAN1 LINK/ACT & 10M/100M LEDs solid On	SDRAM error
WAN2 LINK/ACT & 10M/100M LEDs solid On	Timer/Interrupt error
LAN1 LINK/ACT & 10M/100M LEDs solid On	LAN/WAN error

Rear Panel:

DC 5V WAN2 Reset LAN Ports WAN1

	Reset Button
WAN Ports	Press the Reset button once for a warm
	reboot. To reset the XC-DPG602 to default
Connect the primary Broadband Modem to
	settings, press and hold the reset button for
WAN 1 and the second Broadband Modem
	30 seconds.
on WAN 2.

LAN Ports

Connect the PCs to these ports. Both 10BaseT and 100BaseT connections can be used simultaneously.

Note: Any port will automatically operate as an “Uplink” port if required. Use a standard RJ-45 Ethernet cable to connect to any port to another hub or switch.

Default Settings

When the XC-DPG602 has finished booting, all configuration settings will be set to the factory defaults, including:

•The IP Address is set to its default value of 192.168.1.1 with a Network Mask of 255.255.255.0

•DHCP Server is enabled

•User Name: admin

•Password cleared (no password)

8