Read Mode
Start Setup | End Setup |
[[ [[
Read Mode Settings:
Read Mode
single read | default | T1 |
|
|
|
multiple read (see below) |
| T2 |
|
|
|
continuous read (used mainly for demonstration) |
| T3 |
|
|
|
In multiple read mode, when a bar code has been decoded, the decoded data will be output and the scan engine will keep on reading. When the bar code that has just been output is read again, it will not be output. However, when the scanner cannot decode any labels for some configurable time, it will forget the previous scan and then the same label can be read again.
| multiple read reset time = 1 frame |
| BI |
|
|
|
|
| multiple read reset time = 2 frames |
| BJ |
|
|
|
|
| multiple read reset time = 3 frames |
| BK |
|
|
|
|
Multiple Read | multiple read reset time = 4 frames |
| BL |
Reset Time | multiple read reset time = 5 frames |
| BM |
|
| ||
|
|
|
|
| multiple read reset time = 6 frames | default | BN |
|
|
|
|
| multiple read reset time = 7 frames |
| BO |
|
|
|
|
| multiple read reset time = indefinitely |
| BH |
|
|
|
|
|
|
|
|
Enable/Disable | enable trigger | default | T9 |
Trigger | disable trigger (continuous read) |
| T8 |
|
| ||
|
|
|
|